mmc: tmio: Further fixup runtime PM management at remove

Before calling tmio_mmc_host_probe(), the caller is required to enable
clocks for its device, as to make it accessible when reading/writing
registers during probe.

Therefore, the responsibility to disable these clocks, in the error path of
->probe() and during ->remove(), is better managed outside
tmio_mmc_host_remove(). As a matter of fact, callers of
tmio_mmc_host_remove() already expects this to be the behaviour.

However, there's a problem with tmio_mmc_host_remove() when the Kconfig
option, CONFIG_PM, is set. More precisely, tmio_mmc_host_remove() may then
disable the clock via runtime PM, which leads to clock enable/disable
imbalance problems, when the caller of tmio_mmc_host_remove() also tries to
disable the same clocks.

To solve the problem, let's make sure tmio_mmc_host_remove() leaves the
device with clocks enabled, but also make sure to disable the IRQs, as we
normally do at ->runtime_suspend().
Reported-by: Geert Uytterhoeven <geert+renesas@glider.be>
Reviewed-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Tested-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Cc: stable@vger.kernel.org
Link: https://lore.kernel.org/r/20200519152434.6867-1-ulf.hansson@linaro.orgTested-by: Geert Uytterhoeven <geert+renesas@glider.be>

drivers/mmc/host/tmio_mmc_core.c

@@ -1231,12 +1231,14 @@ void tmio_mmc_host_remove(struct tmio_mmc_host *host)
 	cancel_work_sync(&host->done);
 	cancel_delayed_work_sync(&host->delayed_reset_work);
 	tmio_mmc_release_dma(host);
+	tmio_mmc_disable_mmc_irqs(host, TMIO_MASK_ALL);
 
-	pm_runtime_dont_use_autosuspend(&pdev->dev);
 	if (host->native_hotplug)
 		pm_runtime_put_noidle(&pdev->dev);
-	pm_runtime_put_sync(&pdev->dev);
+
 	pm_runtime_disable(&pdev->dev);
+	pm_runtime_dont_use_autosuspend(&pdev->dev);
+	pm_runtime_put_noidle(&pdev->dev);
 }
 EXPORT_SYMBOL_GPL(tmio_mmc_host_remove);