Commit 4d2fafd1 authored by Tear's avatar Tear Committed by Len Brown

ACPI: Remove Dell Optiplex GX240 from the ACPI blacklist

I have a Dell Optiplex GX240 and when I boot Linux, ACPI gets set up by only
acpi=ht.  dmesg shows the following line:

   DELL GX240 detected: force use of acpi=ht

Everything seemed to be fine.  However, I discovered that everything is not
fine.  The USB controller works so slowly that copying a few (uncached) 1
megabyte large photos from a USB-enabled digital camera takes many minutes
instead of a couple of seconds.

I am using Linux 2.6.21.1 on a Debian 4.0 ("Etch") system.

I thought that this might be related to ACPI.  So I tried to boot with _only_
"acpi=force" appended to the kernel command line.  Voila, the USB controller
started to work at full speed and copying photos from my digital camera took
only seconds.

I tested the system with "acpi=force" and could not find anything which did
not work.

I thought that this might be related to interrupts and APIC as well.  (Note
that this is APIC, not ACPI.) I tried booting with _only_ "noapic" and
"nolapic" appended to the command line.  Again, the USB controller started to
work at full speed.
Signed-off-by: default avatarAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: default avatarLen Brown <len.brown@intel.com>
parent f285e3d3
...@@ -969,14 +969,6 @@ static struct dmi_system_id __initdata acpi_dmi_table[] = { ...@@ -969,14 +969,6 @@ static struct dmi_system_id __initdata acpi_dmi_table[] = {
DMI_MATCH(DMI_PRODUCT_NAME, "PRIMERGY T850"), DMI_MATCH(DMI_PRODUCT_NAME, "PRIMERGY T850"),
}, },
}, },
{
.callback = force_acpi_ht,
.ident = "DELL GX240",
.matches = {
DMI_MATCH(DMI_BOARD_VENDOR, "Dell Computer Corporation"),
DMI_MATCH(DMI_BOARD_NAME, "OptiPlex GX240"),
},
},
{ {
.callback = force_acpi_ht, .callback = force_acpi_ht,
.ident = "HP VISUALIZE NT Workstation", .ident = "HP VISUALIZE NT Workstation",
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment