mmc: core: Rename __mmc_set_signal_voltage() to mmc_set_signal_voltage()

Earlier the mmc_set_signal_voltage() existed, but since it has been renamed
to mmc_set_uhs_voltage(), we can now use that name instead.
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Reviewed-by: Shawn Lin <shawn.lin@rock-chips.com>
Tested-by: Jan Glauber <jglauber@cavium.com>
Tested-by: Stefan Wahren <stefan.wahren@i2se.com>

drivers/mmc/core/core.c

@@ -1631,7 +1631,7 @@ u32 mmc_select_voltage(struct mmc_host *host, u32 ocr)
 	return ocr;
 }
 
-int __mmc_set_signal_voltage(struct mmc_host *host, int signal_voltage)
+int mmc_set_signal_voltage(struct mmc_host *host, int signal_voltage)
 {
 	int err = 0;
 	int old_signal_voltage = host->ios.signal_voltage;
@@ -1691,7 +1691,7 @@ int mmc_set_uhs_voltage(struct mmc_host *host, u32 ocr)
 	host->ios.clock = 0;
 	mmc_set_ios(host);
 
-	if (__mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180)) {
+	if (mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180)) {
 		/*
 		 * Voltages may not have been switched, but we've already
 		 * sent CMD11, so a power cycle is required anyway
@@ -1800,11 +1800,11 @@ void mmc_power_up(struct mmc_host *host, u32 ocr)
 	mmc_set_initial_state(host);
 
 	/* Try to set signal voltage to 3.3V but fall back to 1.8v or 1.2v */
-	if (__mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_330) == 0)
+	if (!mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_330))
 		dev_dbg(mmc_dev(host), "Initial signal voltage of 3.3v\n");
-	else if (__mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180) == 0)
+	else if (!mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180))
 		dev_dbg(mmc_dev(host), "Initial signal voltage of 1.8v\n");
-	else if (__mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_120) == 0)
+	else if (!mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_120))
 		dev_dbg(mmc_dev(host), "Initial signal voltage of 1.2v\n");
 
 	/*

drivers/mmc/core/core.h

@@ -49,7 +49,7 @@ void mmc_set_bus_mode(struct mmc_host *host, unsigned int mode);
 void mmc_set_bus_width(struct mmc_host *host, unsigned int width);
 u32 mmc_select_voltage(struct mmc_host *host, u32 ocr);
 int mmc_set_uhs_voltage(struct mmc_host *host, u32 ocr);
-int __mmc_set_signal_voltage(struct mmc_host *host, int signal_voltage);
+int mmc_set_signal_voltage(struct mmc_host *host, int signal_voltage);
 void mmc_set_timing(struct mmc_host *host, unsigned int timing);
 void mmc_set_driver_type(struct mmc_host *host, unsigned int drv_type);
 int mmc_select_drive_strength(struct mmc_card *card, unsigned int max_dtr,

drivers/mmc/core/mmc.c

@@ -1122,14 +1122,14 @@ static int mmc_select_hs_ddr(struct mmc_card *card)
 	 */
 	err = -EINVAL;
 	if (card->mmc_avail_type & EXT_CSD_CARD_TYPE_DDR_1_2V)
-		err = __mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_120);
+		err = mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_120);
 
 	if (err && (card->mmc_avail_type & EXT_CSD_CARD_TYPE_DDR_1_8V))
-		err = __mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180);
+		err = mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180);
 
 	/* make sure vccq is 3.3v after switching disaster */
 	if (err)
-		err = __mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_330);
+		err = mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_330);
 
 	return err;
 }
@@ -1296,10 +1296,10 @@ static int mmc_select_hs400es(struct mmc_card *card)
 	}
 
 	if (card->mmc_avail_type & EXT_CSD_CARD_TYPE_HS400_1_2V)
-		err = __mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_120);
+		err = mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_120);
 
 	if (err && card->mmc_avail_type & EXT_CSD_CARD_TYPE_HS400_1_8V)
-		err = __mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180);
+		err = mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180);
 
 	/* If fails try again during next card power cycle */
 	if (err)
@@ -1405,10 +1405,10 @@ static int mmc_select_hs200(struct mmc_card *card)
 
 	old_signal_voltage = host->ios.signal_voltage;
 	if (card->mmc_avail_type & EXT_CSD_CARD_TYPE_HS200_1_2V)
-		err = __mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_120);
+		err = mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_120);
 
 	if (err && card->mmc_avail_type & EXT_CSD_CARD_TYPE_HS200_1_8V)
-		err = __mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180);
+		err = mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180);
 
 	/* If fails try again during next card power cycle */
 	if (err)
@@ -1450,7 +1450,7 @@ static int mmc_select_hs200(struct mmc_card *card)
 err:
 	if (err) {
 		/* fall back to the old signal voltage, if fails report error */
-		if (__mmc_set_signal_voltage(host, old_signal_voltage))
+		if (mmc_set_signal_voltage(host, old_signal_voltage))
 			err = -EIO;
 
 		pr_err("%s: %s failed, error %d\n", mmc_hostname(card->host),