Commit 55f2ac33 authored by Caesar Wang's avatar Caesar Wang Committed by Zhang Rui

thermal: trivial: fix the typo

See the thermal code, the obvious typo from my editor.
Signed-off-by: default avatarCaesar Wang <wxt@rock-chips.com>
Signed-off-by: default avatarEduardo Valentin <edubezval@gmail.com>
Signed-off-by: default avatarZhang Rui <rui.zhang@intel.com>
parent 57027db0
......@@ -62,7 +62,7 @@ For more examples of cooling devices, refer to the example sections below.
Required properties:
- #cooling-cells: Used to provide cooling device specific information
Type: unsigned while referring to it. Must be at least 2, in order
Size: one cell to specify minimum and maximum cooling state used
Size: one cell to specify minimum and maximum cooling state used
in the reference. The first cell is the minimum
cooling state requested and the second cell is
the maximum cooling state requested in the reference.
......@@ -119,7 +119,7 @@ Required properties:
Optional property:
- contribution: The cooling contribution to the thermal zone of the
Type: unsigned referred cooling device at the referred trip point.
Size: one cell The contribution is a ratio of the sum
Size: one cell The contribution is a ratio of the sum
of all cooling contributions within a thermal zone.
Note: Using the THERMAL_NO_LIMIT (-1UL) constant in the cooling-device phandle
......@@ -145,7 +145,7 @@ Required properties:
Size: one cell
- thermal-sensors: A list of thermal sensor phandles and sensor specifier
Type: list of used while monitoring the thermal zone.
Type: list of used while monitoring the thermal zone.
phandles + sensor
specifier
......@@ -473,7 +473,7 @@ thermal-zones {
<&adc>; /* pcb north */
/* hotspot = 100 * bandgap - 120 * adc + 484 */
coefficients = <100 -120 484>;
coefficients = <100 -120 484>;
trips {
...
......@@ -502,7 +502,7 @@ from the ADC sensor. The binding would be then:
thermal-sensors = <&adc>;
/* hotspot = 1 * adc + 6000 */
coefficients = <1 6000>;
coefficients = <1 6000>;
(d) - Board thermal
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment