Commit 58048e6d authored by David S. Miller's avatar David S. Miller

Merge branch 'genet-gphy'

Florian Fainelli says:

====================
net: bcmgenet: support for new GPHY revision scheme

These two patches update the GENET GPHY revision logic to account for some
of our newer designs starting with GPHY rev G0.
====================
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parents 6db70e3e 60efff0c
......@@ -2504,6 +2504,7 @@ static void bcmgenet_set_hw_params(struct bcmgenet_priv *priv)
struct bcmgenet_hw_params *params;
u32 reg;
u8 major;
u16 gphy_rev;
if (GENET_IS_V4(priv)) {
bcmgenet_dma_regs = bcmgenet_dma_regs_v3plus;
......@@ -2552,8 +2553,29 @@ static void bcmgenet_set_hw_params(struct bcmgenet_priv *priv)
* to pass this information to the PHY driver. The PHY driver expects
* to find the PHY major revision in bits 15:8 while the GENET register
* stores that information in bits 7:0, account for that.
*
* On newer chips, starting with PHY revision G0, a new scheme is
* deployed similar to the Starfighter 2 switch with GPHY major
* revision in bits 15:8 and patch level in bits 7:0. Major revision 0
* is reserved as well as special value 0x01ff, we have a small
* heuristic to check for the new GPHY revision and re-arrange things
* so the GPHY driver is happy.
*/
priv->gphy_rev = (reg & 0xffff) << 8;
gphy_rev = reg & 0xffff;
/* This is the good old scheme, just GPHY major, no minor nor patch */
if ((gphy_rev & 0xf0) != 0)
priv->gphy_rev = gphy_rev << 8;
/* This is the new scheme, GPHY major rolls over with 0x10 = rev G0 */
else if ((gphy_rev & 0xff00) != 0)
priv->gphy_rev = gphy_rev;
/* This is reserved so should require special treatment */
else if (gphy_rev == 0 || gphy_rev == 0x01ff) {
pr_warn("Invalid GPHY revision detected: 0x%04x\n", gphy_rev);
return;
}
#ifdef CONFIG_PHYS_ADDR_T_64BIT
if (!(params->flags & GENET_HAS_40BITS))
......
......@@ -252,6 +252,8 @@ static int bcm7xxx_28nm_config_init(struct phy_device *phydev)
break;
case 0xe0:
case 0xf0:
/* Rev G0 introduces a roll over */
case 0x10:
ret = bcm7xxx_28nm_e0_plus_afe_config_init(phydev);
break;
default:
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment