ARM: i.MX28: shift frac value in _CLK_SET_RATE

Noticed when setting SSP0 in clk_set_rate, _CLK_SET_RATE attempts to
reset the clock divider for the SSP0 parent clock, in this case
IO0FRAC. Bits 24-29 of HW_CLKCTRL_FRAC0 are cleared correctly, but
when the new frac value is written the value isn't shifted up to write
the correct bit-field.  This results in IO0FRAC being set to 0 and
CPUFRAC being corrupted.

This should occur when writing IO1FRAC, EMIFRAC in HW_CLKCTRL_FRAC0
and GPMIFRAC, HSADCFRAC in HW_CLKCTRL_FRAC1.

Tested on custom i.MX28 board with SSP0 SPI driver.
Signed-off-by: Matt Burtch <matt@grid-net.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

arch/arm/mach-mxs/clock-mx28.c

@@ -349,7 +349,7 @@ static int name##_set_rate(struct clk *clk, unsigned long rate)		\
 									\
 		reg = __raw_readl(CLKCTRL_BASE_ADDR + HW_CLKCTRL_##fr);	\
 		reg &= ~BM_CLKCTRL_##fr##_##fs##FRAC;			\
-		reg |= frac;						\
+		reg |= frac << BP_CLKCTRL_##fr##_##fs##FRAC;		\
 		__raw_writel(reg, CLKCTRL_BASE_ADDR + HW_CLKCTRL_##fr);	\
 	}								\
 									\