Commit 5c020dc6 authored by Luis R. Rodriguez's avatar Luis R. Rodriguez Committed by John W. Linville

ath9k: Allow user to change tx power when asked

We were also changing tx power even when we were not asked to,
this enforces the change only when we are asked nicely. When
not asked we simply try to use the max power, we don't tx power
at all for rate control.
Signed-off-by: default avatarLuis R. Rodriguez <lrodriguez@atheros.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent f97e4007
......@@ -1250,7 +1250,8 @@ static int ath9k_config(struct ieee80211_hw *hw, u32 changed)
sc->sc_ah->ah_channels[pos].chanmode =
ath_get_extchanmode(sc, curchan);
sc->sc_config.txpowlimit = 2 * conf->power_level;
if (changed & IEEE80211_CONF_CHANGE_POWER)
sc->sc_config.txpowlimit = 2 * conf->power_level;
/* set h/w channel */
if (ath_set_channel(sc, &sc->sc_ah->ah_channels[pos]) < 0)
......
......@@ -230,7 +230,13 @@ static int ath_tx_prepare(struct ath_softc *sc,
txctl->if_id = 0;
txctl->frmlen = skb->len + FCS_LEN - (hdrlen & 3);
txctl->txpower = MAX_RATE_POWER; /* FIXME */
/* Always try at highest power possible unless the the device
* was configured by the user to use another power. */
if (likely(sc->sc_config.txpowlimit == ATH_TXPOWER_MAX))
txctl->txpower = ATH_TXPOWER_MAX;
else
txctl->txpower = sc->sc_config.txpowlimit;
/* Fill Key related fields */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment