[media] OMAP_VOUT: Fix build break caused by update_mode removal in DSS2

The DSS2 driver does not support the configuration of the update_mode of a
panel anymore. Remove the setting of update_mode done in omap_vout_probe().
Ignore configuration of TE since omap_vout driver doesn't support manual update
displays anyway.
Signed-off-by: Archit Taneja <archit@ti.com>
Tested-by: Koen Kooi <koen@dominion.thruhere.net>
Signed-off-by: Vaibhav Hiremath <hvaibhav@ti.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>

drivers/media/video/omap/omap_vout.c

@@ -2194,19 +2194,6 @@ static int __init omap_vout_probe(struct platform_device *pdev)
 					"'%s' Display already enabled\n",
 					def_display->name);
 			}
-			/* set the update mode */
-			if (def_display->caps &
-					OMAP_DSS_DISPLAY_CAP_MANUAL_UPDATE) {
-				if (dssdrv->enable_te)
-					dssdrv->enable_te(def_display, 0);
-				if (dssdrv->set_update_mode)
-					dssdrv->set_update_mode(def_display,
-							OMAP_DSS_UPDATE_MANUAL);
-			} else {
-				if (dssdrv->set_update_mode)
-					dssdrv->set_update_mode(def_display,
-							OMAP_DSS_UPDATE_AUTO);
-			}
 		}
 	}