Commit 5fb3d522 authored by Paul Walmsley's avatar Paul Walmsley

ARM: OMAP2+: hwmod: add flag to prevent hwmod code from touching IP block during init

Add HWMOD_EXT_OPT_MAIN_CLK flag to indicate that this IP block is
dependent on an off-chip functional clock that is not guaranteed to be
present during initialization.  IP blocks marked with this flag are
left in the INITIALIZED state during kernel init.

This is a workaround for a hardware problem.  It should be possible to
guarantee that at least one clock source will be present and active
for any IP block's main functional clock.  This ensures that the hwmod
code can enable and reset the IP block.  Resetting the IP block during
kernel init prevents any bogus bootloader, ROM code, or previous OS
configuration from affecting the kernel.  Hopefully a clock
multiplexer can be added on future SoCs.

N.B., at some point in the future, it should be possible to query the
clock framework for this type of information.  Then this flag should
no longer be needed.
Signed-off-by: default avatarPaul Walmsley <paul@pwsan.com>
Cc: Benoît Cousson <b-cousson@ti.com>
parent 613ad0e9
...@@ -2384,6 +2384,9 @@ static int __init _setup_reset(struct omap_hwmod *oh) ...@@ -2384,6 +2384,9 @@ static int __init _setup_reset(struct omap_hwmod *oh)
if (oh->_state != _HWMOD_STATE_INITIALIZED) if (oh->_state != _HWMOD_STATE_INITIALIZED)
return -EINVAL; return -EINVAL;
if (oh->flags & HWMOD_EXT_OPT_MAIN_CLK)
return -EPERM;
if (oh->rst_lines_cnt == 0) { if (oh->rst_lines_cnt == 0) {
r = _enable(oh); r = _enable(oh);
if (r) { if (r) {
......
...@@ -443,6 +443,11 @@ struct omap_hwmod_omap4_prcm { ...@@ -443,6 +443,11 @@ struct omap_hwmod_omap4_prcm {
* in order to complete the reset. Optional clocks will be disabled * in order to complete the reset. Optional clocks will be disabled
* again after the reset. * again after the reset.
* HWMOD_16BIT_REG: Module has 16bit registers * HWMOD_16BIT_REG: Module has 16bit registers
* HWMOD_EXT_OPT_MAIN_CLK: The only main functional clock source for
* this IP block comes from an off-chip source and is not always
* enabled. This prevents the hwmod code from being able to
* enable and reset the IP block early. XXX Eventually it should
* be possible to query the clock framework for this information.
*/ */
#define HWMOD_SWSUP_SIDLE (1 << 0) #define HWMOD_SWSUP_SIDLE (1 << 0)
#define HWMOD_SWSUP_MSTANDBY (1 << 1) #define HWMOD_SWSUP_MSTANDBY (1 << 1)
...@@ -453,6 +458,7 @@ struct omap_hwmod_omap4_prcm { ...@@ -453,6 +458,7 @@ struct omap_hwmod_omap4_prcm {
#define HWMOD_NO_IDLEST (1 << 6) #define HWMOD_NO_IDLEST (1 << 6)
#define HWMOD_CONTROL_OPT_CLKS_IN_RESET (1 << 7) #define HWMOD_CONTROL_OPT_CLKS_IN_RESET (1 << 7)
#define HWMOD_16BIT_REG (1 << 8) #define HWMOD_16BIT_REG (1 << 8)
#define HWMOD_EXT_OPT_MAIN_CLK (1 << 9)
/* /*
* omap_hwmod._int_flags definitions * omap_hwmod._int_flags definitions
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment