power: bq24257: Remove IRQ config through stat-gpios

At the time the driver was written GpioInt resources in ACPI were not
passed to the driver in client->irq, as opposed to DT enumeration. To
accommodate this use case, a "stat-gpios" property was introduced to
allow configuring the IRQ.

However this issue with ACPI was fixed in commit "845c8770 i2c / ACPI:
Assign IRQ for devices that have GpioInt automatically" and makes this
workaround no longer necessary, hence we can remove the support for the
"stat-gpios" property and the associated code from the bq24257 driver.
Signed-off-by: Andreas Dannenberg <dannenberg@ti.com>
Signed-off-by: Sebastian Reichel <sre@kernel.org>

drivers/power/bq24257_charger.c

@@ -36,7 +36,6 @@
 #define BQ24257_REG_7			0x06
 
 #define BQ24257_MANUFACTURER		"Texas Instruments"
-#define BQ24257_STAT_IRQ		"stat"
 #define BQ24257_PG_GPIO			"pg"
 
 #define BQ24257_ILIM_SET_DELAY		1000	/* msec */
@@ -606,19 +605,6 @@ static int bq24257_power_supply_init(struct bq24257_device *bq)
 	return 0;
 }
 
-static int bq24257_irq_probe(struct bq24257_device *bq)
-{
-	struct gpio_desc *stat_irq;
-
-	stat_irq = devm_gpiod_get_index(bq->dev, BQ24257_STAT_IRQ, 0, GPIOD_IN);
-	if (IS_ERR(stat_irq)) {
-		dev_err(bq->dev, "could not probe stat_irq pin\n");
-		return PTR_ERR(stat_irq);
-	}
-
-	return gpiod_to_irq(stat_irq);
-}
-
 static int bq24257_pg_gpio_probe(struct bq24257_device *bq)
 {
 	bq->pg = devm_gpiod_get_index(bq->dev, BQ24257_PG_GPIO, 0, GPIOD_IN);
@@ -740,21 +726,15 @@ static int bq24257_probe(struct i2c_client *client,
 		return ret;
 	}
 
-	if (client->irq <= 0)
-		client->irq = bq24257_irq_probe(bq);
-
-	if (client->irq < 0) {
-		dev_err(dev, "no irq resource found\n");
-		return client->irq;
-	}
-
 	ret = devm_request_threaded_irq(dev, client->irq, NULL,
 					bq24257_irq_handler_thread,
 					IRQF_TRIGGER_FALLING |
 					IRQF_TRIGGER_RISING | IRQF_ONESHOT,
-					BQ24257_STAT_IRQ, bq);
-	if (ret)
+					"bq24257", bq);
+	if (ret) {
+		dev_err(dev, "Failed to request IRQ #%d\n", client->irq);
 		return ret;
+	}
 
 	ret = bq24257_power_supply_init(bq);
 	if (ret < 0)