rtl8xxxu: Remove backing up certain registers, which was never used

This was inspired by the vendor driver, but in the end never used for
anything.
Signed-off-by: Jes Sorensen <Jes.Sorensen@redhat.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c

@@ -5815,20 +5815,6 @@ static int rtl8xxxu_init_device(struct ieee80211_hw *hw)
 	/* Init BT hw config. */
 	rtl8xxxu_init_bt(priv);
 
-	/*
-	 * Not sure if we really need to save these parameters, but the
-	 * vendor driver does
-	 */
-	val32 = rtl8xxxu_read32(priv, REG_FPGA0_XA_HSSI_PARM2);
-	if (val32 & FPGA0_HSSI_PARM2_CCK_HIGH_PWR)
-		priv->path_a_hi_power = 1;
-
-	val32 = rtl8xxxu_read32(priv, REG_OFDM0_TRX_PATH_ENABLE);
-	priv->path_a_rf_paths = val32 & OFDM_RF_PATH_RX_MASK;
-
-	val32 = rtl8xxxu_read32(priv, REG_OFDM0_XA_AGC_CORE1);
-	priv->path_a_ig_value = val32 & OFDM0_X_AGC_CORE1_IGI_MASK;
-
 	/* Set NAV_UPPER to 30000us */
 	val8 = ((30000 + NAV_UPPER_UNIT - 1) / NAV_UPPER_UNIT);
 	rtl8xxxu_write8(priv, REG_NAV_UPPER, val8);

drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.h

@@ -785,13 +785,10 @@ struct rtl8xxxu_priv {
 	u32 ep_tx_high_queue:1;
 	u32 ep_tx_normal_queue:1;
 	u32 ep_tx_low_queue:1;
-	u32 path_a_hi_power:1;
-	u32 path_a_rf_paths:4;
 	unsigned int pipe_interrupt;
 	unsigned int pipe_in;
 	unsigned int pipe_out[TXDESC_QUEUE_MAX];
 	u8 out_ep[RTL8XXXU_OUT_ENDPOINTS];
-	u8 path_a_ig_value;
 	u8 ep_tx_count;
 	u8 rf_paths;
 	u8 rx_paths;