staging: r8188eu: txpktbuf_bndy does not depend on wifi_spec

Remove the if clause that sets txpktbuf_bndy. Both branches set the same
value.

Tested-by: Philipp Hortmann <philipp.g.hortmann@gmail.com> # Edimax N150
Signed-off-by: Martin Kaiser <martin@kaiser.cx>
Link: https://lore.kernel.org/r/20220806194304.777059-1-martin@kaiser.cxSigned-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/staging/r8188eu/hal/usb_halinit.c

@@ -567,7 +567,6 @@ u32 rtl8188eu_hal_init(struct adapter *Adapter)
 {
 	u8 value8 = 0;
 	u16  value16;
-	u8 txpktbuf_bndy;
 	u32 status = _SUCCESS;
 	int res;
 	struct hal_data_8188e *haldata = &Adapter->haldata;
@@ -600,13 +599,6 @@ u32 rtl8188eu_hal_init(struct adapter *Adapter)
 	/*  HW GPIO pin. Before PHY_RFConfig8192C. */
 	/*  2010/08/26 MH If Efuse does not support sective suspend then disable the function. */
 
-	if (!pregistrypriv->wifi_spec) {
-		txpktbuf_bndy = TX_PAGE_BOUNDARY_88E;
-	} else {
-		/*  for WMM */
-		txpktbuf_bndy = WMM_NORMAL_TX_PAGE_BOUNDARY_88E;
-	}
-
 	_InitQueueReservedPage(Adapter);
 	_InitQueuePriority(Adapter);
 	_InitPageBoundary(Adapter);
@@ -647,9 +639,9 @@ u32 rtl8188eu_hal_init(struct adapter *Adapter)
 	if (status == _FAIL)
 		goto exit;
 
-	_InitTxBufferBoundary(Adapter, txpktbuf_bndy);
+	_InitTxBufferBoundary(Adapter, TX_PAGE_BOUNDARY_88E);
 
-	status =  InitLLTTable(Adapter, txpktbuf_bndy);
+	status =  InitLLTTable(Adapter, TX_PAGE_BOUNDARY_88E);
 	if (status == _FAIL)
 		goto exit;
 

drivers/staging/r8188eu/include/rtl8188e_hal.h

@@ -51,12 +51,6 @@
 
 #define TX_PAGE_BOUNDARY_88E (TX_TOTAL_PAGE_NUMBER_88E + 1)
 
-/* Note: For Normal Chip Setting ,modify later */
-#define WMM_NORMAL_TX_TOTAL_PAGE_NUMBER			\
-	TX_TOTAL_PAGE_NUMBER_88E  /* 0xA9 , 0xb0=>176=>22k */
-#define WMM_NORMAL_TX_PAGE_BOUNDARY_88E			\
-	(WMM_NORMAL_TX_TOTAL_PAGE_NUMBER + 1) /* 0xA9 */
-
 #include "HalVerDef.h"
 #include "hal_com.h"