Merge tag 'for-usb-linus-2013-10-09' of...

Merge tag 'for-usb-linus-2013-10-09' of git://git.kernel.org/pub/scm/linux/kernel/git/sarah/xhci into usb-linus

Pull xhci USB fixes from Sarah:

xhci: Bug fixes and quirks for 3.12

Hi Greg,

Here's four patches for 3.12.

The first patch is a bug fix for the USB 2.0 Link PM registers that I sent
out to the list a long time ago (August), but forgot to queue up.  The
second and fourth patches are quirks for xHCI hosts.  These patches are
marked for stable.  The third patch fixes a bug uncovered with sparse.

Sarah Sharp

drivers/usb/host/pci-quirks.c

@@ -799,7 +799,7 @@ void usb_enable_intel_xhci_ports(struct pci_dev *xhci_pdev)
 	 * switchable ports.
 	 */
 	pci_write_config_dword(xhci_pdev, USB_INTEL_USB3_PSSEN,
-			cpu_to_le32(ports_available));
+			ports_available);
 
 	pci_read_config_dword(xhci_pdev, USB_INTEL_USB3_PSSEN,
 			&ports_available);
@@ -821,7 +821,7 @@ void usb_enable_intel_xhci_ports(struct pci_dev *xhci_pdev)
 	 * host.
 	 */
 	pci_write_config_dword(xhci_pdev, USB_INTEL_XUSB2PR,
-			cpu_to_le32(ports_available));
+			ports_available);
 
 	pci_read_config_dword(xhci_pdev, USB_INTEL_XUSB2PR,
 			&ports_available);

drivers/usb/host/xhci-hub.c

@@ -1157,18 +1157,6 @@ int xhci_bus_suspend(struct usb_hcd *hcd)
 		t1 = xhci_port_state_to_neutral(t1);
 		if (t1 != t2)
 			xhci_writel(xhci, t2, port_array[port_index]);
-
-		if (hcd->speed != HCD_USB3) {
-			/* enable remote wake up for USB 2.0 */
-			__le32 __iomem *addr;
-			u32 tmp;
-
-			/* Get the port power control register address. */
-			addr = port_array[port_index] + PORTPMSC;
-			tmp = xhci_readl(xhci, addr);
-			tmp |= PORT_RWE;
-			xhci_writel(xhci, tmp, addr);
-		}
 	}
 	hcd->state = HC_STATE_SUSPENDED;
 	bus_state->next_statechange = jiffies + msecs_to_jiffies(10);
@@ -1247,20 +1235,6 @@ int xhci_bus_resume(struct usb_hcd *hcd)
 				xhci_ring_device(xhci, slot_id);
 		} else
 			xhci_writel(xhci, temp, port_array[port_index]);
-
-		if (hcd->speed != HCD_USB3) {
-			/* disable remote wake up for USB 2.0 */
-			__le32 __iomem *addr;
-			u32 tmp;
-
-			/* Add one to the port status register address to get
-			 * the port power control register address.
-			 */
-			addr = port_array[port_index] + PORTPMSC;
-			tmp = xhci_readl(xhci, addr);
-			tmp &= ~PORT_RWE;
-			xhci_writel(xhci, tmp, addr);
-		}
 	}
 
 	(void) xhci_readl(xhci, &xhci->op_regs->command);

drivers/usb/host/xhci-pci.c

@@ -35,6 +35,9 @@
 #define PCI_VENDOR_ID_ETRON		0x1b6f
 #define PCI_DEVICE_ID_ASROCK_P67	0x7023
 
+#define PCI_DEVICE_ID_INTEL_LYNXPOINT_XHCI	0x8c31
+#define PCI_DEVICE_ID_INTEL_LYNXPOINT_LP_XHCI	0x9c31
+
 static const char hcd_name[] = "xhci_hcd";
 
 /* called after powerup, by probe or system-pm "wakeup" */
@@ -69,6 +72,14 @@ static void xhci_pci_quirks(struct device *dev, struct xhci_hcd *xhci)
 				"QUIRK: Fresco Logic xHC needs configure"
 				" endpoint cmd after reset endpoint");
 		}
+		if (pdev->device == PCI_DEVICE_ID_FRESCO_LOGIC_PDK &&
+				pdev->revision == 0x4) {
+			xhci->quirks |= XHCI_SLOW_SUSPEND;
+			xhci_dbg_trace(xhci, trace_xhci_dbg_quirks,
+				"QUIRK: Fresco Logic xHC revision %u"
+				"must be suspended extra slowly",
+				pdev->revision);
+		}
 		/* Fresco Logic confirms: all revisions of this chip do not
 		 * support MSI, even though some of them claim to in their PCI
 		 * capabilities.
@@ -110,6 +121,15 @@ static void xhci_pci_quirks(struct device *dev, struct xhci_hcd *xhci)
 		xhci->quirks |= XHCI_SPURIOUS_REBOOT;
 		xhci->quirks |= XHCI_AVOID_BEI;
 	}
+	if (pdev->vendor == PCI_VENDOR_ID_INTEL &&
+	    (pdev->device == PCI_DEVICE_ID_INTEL_LYNXPOINT_XHCI ||
+	     pdev->device == PCI_DEVICE_ID_INTEL_LYNXPOINT_LP_XHCI)) {
+		/* Workaround for occasional spurious wakeups from S5 (or
+		 * any other sleep) on Haswell machines with LPT and LPT-LP
+		 * with the new Intel BIOS
+		 */
+		xhci->quirks |= XHCI_SPURIOUS_WAKEUP;
+	}
 	if (pdev->vendor == PCI_VENDOR_ID_ETRON &&
 			pdev->device == PCI_DEVICE_ID_ASROCK_P67) {
 		xhci->quirks |= XHCI_RESET_ON_RESUME;
@@ -217,6 +237,11 @@ static void xhci_pci_remove(struct pci_dev *dev)
 		usb_put_hcd(xhci->shared_hcd);
 	}
 	usb_hcd_pci_remove(dev);
+
+	/* Workaround for spurious wakeups at shutdown with HSW */
+	if (xhci->quirks & XHCI_SPURIOUS_WAKEUP)
+		pci_set_power_state(dev, PCI_D3hot);
+
 	kfree(xhci);
 }
 

drivers/usb/host/xhci.c

@@ -730,6 +730,9 @@ void xhci_shutdown(struct usb_hcd *hcd)
 
 	spin_lock_irq(&xhci->lock);
 	xhci_halt(xhci);
+	/* Workaround for spurious wakeups at shutdown with HSW */
+	if (xhci->quirks & XHCI_SPURIOUS_WAKEUP)
+		xhci_reset(xhci);
 	spin_unlock_irq(&xhci->lock);
 
 	xhci_cleanup_msix(xhci);
@@ -737,6 +740,10 @@ void xhci_shutdown(struct usb_hcd *hcd)
 	xhci_dbg_trace(xhci, trace_xhci_dbg_init,
 			"xhci_shutdown completed - status = %x",
 			xhci_readl(xhci, &xhci->op_regs->status));
+
+	/* Yet another workaround for spurious wakeups at shutdown with HSW */
+	if (xhci->quirks & XHCI_SPURIOUS_WAKEUP)
+		pci_set_power_state(to_pci_dev(hcd->self.controller), PCI_D3hot);
 }
 
 #ifdef CONFIG_PM
@@ -839,6 +846,7 @@ static void xhci_clear_command_ring(struct xhci_hcd *xhci)
 int xhci_suspend(struct xhci_hcd *xhci)
 {
 	int			rc = 0;
+	unsigned int		delay = XHCI_MAX_HALT_USEC;
 	struct usb_hcd		*hcd = xhci_to_hcd(xhci);
 	u32			command;
 
@@ -861,8 +869,12 @@ int xhci_suspend(struct xhci_hcd *xhci)
 	command = xhci_readl(xhci, &xhci->op_regs->command);
 	command &= ~CMD_RUN;
 	xhci_writel(xhci, command, &xhci->op_regs->command);
+
+	/* Some chips from Fresco Logic need an extraordinary delay */
+	delay *= (xhci->quirks & XHCI_SLOW_SUSPEND) ? 10 : 1;
+
 	if (xhci_handshake(xhci, &xhci->op_regs->status,
-		      STS_HALT, STS_HALT, XHCI_MAX_HALT_USEC)) {
+		      STS_HALT, STS_HALT, delay)) {
 		xhci_warn(xhci, "WARN: xHC CMD_RUN timeout\n");
 		spin_unlock_irq(&xhci->lock);
 		return -ETIMEDOUT;

drivers/usb/host/xhci.h

@@ -1548,6 +1548,8 @@ struct xhci_hcd {
 #define XHCI_COMP_MODE_QUIRK	(1 << 14)
 #define XHCI_AVOID_BEI		(1 << 15)
 #define XHCI_PLAT		(1 << 16)
+#define XHCI_SLOW_SUSPEND	(1 << 17)
+#define XHCI_SPURIOUS_WAKEUP	(1 << 18)
 	unsigned int		num_active_eps;
 	unsigned int		limit_active_eps;
 	/* There are two roothubs to keep track of bus suspend info for */