Commit 63e135a7 authored by Roger Quadros's avatar Roger Quadros Committed by Tony Lindgren

ARM: OMAP3: 3630SDP: Adapt to ehci-omap changes

Use usbhs_init_phys() to register the PHY's RESET regulators
and the NOP PHY devices.
Signed-off-by: default avatarRoger Quadros <rogerq@ti.com>
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
parent 0047c909
......@@ -53,16 +53,23 @@ static void enable_board_wakeup_source(void)
OMAP_WAKEUP_EN | OMAP_PIN_INPUT_PULLUP);
}
static struct usbhs_phy_data phy_data[] __initdata = {
{
.port = 1,
.reset_gpio = 126,
.vcc_gpio = -EINVAL,
},
{
.port = 2,
.reset_gpio = 61,
.vcc_gpio = -EINVAL,
},
};
static struct usbhs_omap_platform_data usbhs_bdata __initdata = {
.port_mode[0] = OMAP_EHCI_PORT_MODE_PHY,
.port_mode[1] = OMAP_EHCI_PORT_MODE_PHY,
.port_mode[2] = OMAP_USBHS_PORT_MODE_UNUSED,
.phy_reset = true,
.reset_gpio_port[0] = 126,
.reset_gpio_port[1] = 61,
.reset_gpio_port[2] = -EINVAL
};
#ifdef CONFIG_OMAP_MUX
......@@ -199,6 +206,8 @@ static void __init omap_sdp_init(void)
board_smc91x_init();
board_flash_init(sdp_flash_partitions, chip_sel_sdp, NAND_BUSWIDTH_16);
enable_board_wakeup_source();
usbhs_init_phys(phy_data, ARRAY_SIZE(phy_data));
usbhs_init(&usbhs_bdata);
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment