Commit 641c7673 authored by Andy Whitcroft's avatar Andy Whitcroft Committed by Linus Torvalds

[PATCH] sparsemem swiss cheese numa layouts

The part of the sparsemem patch which modifies memmap_init_zone() has recently
become a problem.  It changes behavior so that there is a call to
pfn_to_page() for each individual page inside of a node's range:
node_start_pfn through node_end_pfn.  It used to simply do this once, at the
beginning of the node, but having sparsemem's non-contiguous mem_map[]s inside
of a node made it necessary to change.

Mike Kravetz recently wrote a patch which made the NUMA code accept some new
kinds of layouts.  The system's memory was laid out like this, with node 0's
memory in two pieces: one before and one after node 1's memory:

	Node 0: +++++     +++++
	Node 1:      +++++

Previous behavior before Mike's patch was to assign nodes like this:

	Node 0: 00000     XXXXX
	Node 1:      11111

Where the 'X' areas were simply thrown away.  The new behavior was to make the
pg_data_t span node 0 across all of its areas, including areas that are really
node 1's: Node 0: 000000000000000 Node 1: 11111

This wastes a little bit of mem_map space, but ends up being OK, and more
fully utilizes the system's memory.  memmap_init_zone() initializes all of the
"struct page"s for node 0, even for the "hole", but those never get used,
because there is no pfn_to_page() that resolves to those pages.  However, only
calling pfn_to_page() once, memmap_init_zone() always uses the pages that were
allocated for node0->node_mem_map because:

	struct page *start = pfn_to_page(start_pfn);
	// effectively start = &node->node_mem_map[0]
	for (page = start; page < (start + size); page++) {
		init_page_here();...
		page++;
	}

Slow, and wasteful, but generally harmless.

But, modify that to call pfn_to_page() for each loop iteration (like sparsemem
does):

	for (pfn = start_pfn; pfn < < (start_pfn + size); pfn++++) {
		page = pfn_to_page(pfn);
	}

And you end up trying to initialize node 1's pages too early, along with bogus
data from node 0.  This patch checks for those weird layouts and declines to
touch the pages, making the more frequent pfn_to_page() calls OK to do.
Signed-off-by: default avatarDave Hansen <haveblue@us.ibm.com>
Signed-off-by: default avatarAndy Whitcroft <apw@shadowen.org>
Signed-off-by: default avatarAndrew Morton <akpm@osdl.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@osdl.org>
parent 05b79bdc
......@@ -211,6 +211,18 @@ config ARCH_FLATMEM_ENABLE
source "mm/Kconfig"
# Some NUMA nodes have memory ranges that span
# other nodes. Even though a pfn is valid and
# between a node's start and end pfns, it may not
# reside on that node.
#
# This is a relatively temporary hack that should
# be able to go away when sparsemem is fully in
# place
config NODES_SPAN_OTHER_NODES
def_bool y
depends on NEED_MULTIPLE_NODES
config NUMA
bool "NUMA support"
depends on DISCONTIGMEM
......
......@@ -528,6 +528,12 @@ void sparse_init(void);
#define sparse_init() do {} while (0)
#endif /* CONFIG_SPARSEMEM */
#ifdef CONFIG_NODES_SPAN_OTHER_NODES
#define early_pfn_in_nid(pfn, nid) (early_pfn_to_nid(pfn) == (nid))
#else
#define early_pfn_in_nid(pfn, nid) (1)
#endif
#ifndef early_pfn_valid
#define early_pfn_valid(pfn) (1)
#endif
......
......@@ -1656,6 +1656,8 @@ void __init memmap_init_zone(unsigned long size, int nid, unsigned long zone,
for (pfn = start_pfn; pfn < end_pfn; pfn++, page++) {
if (!early_pfn_valid(pfn))
continue;
if (!early_pfn_in_nid(pfn, nid))
continue;
page = pfn_to_page(pfn);
set_page_links(page, zone, nid, pfn);
set_page_count(page, 0);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment