wlcore: print the sdio buffer after reading it

fix an issue where we printed the sdio buffer before
actually read it.
Signed-off-by: Guy Mishol <guym@ti.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/ti/wlcore/sdio.c

@@ -81,13 +81,6 @@ static int __must_check wl12xx_sdio_raw_read(struct device *child, int addr,
 
 	sdio_claim_host(func);
 
-	if (unlikely(dump)) {
-		printk(KERN_DEBUG "wlcore_sdio: READ from 0x%04x\n", addr);
-		print_hex_dump(KERN_DEBUG, "wlcore_sdio: READ ",
-				DUMP_PREFIX_OFFSET, 16, 1,
-				buf, len, false);
-	}
-
 	if (unlikely(addr == HW_ACCESS_ELP_CTRL_REG)) {
 		((u8 *)buf)[0] = sdio_f0_readb(func, addr, &ret);
 		dev_dbg(child->parent, "sdio read 52 addr 0x%x, byte 0x%02x\n",
@@ -107,6 +100,13 @@ static int __must_check wl12xx_sdio_raw_read(struct device *child, int addr,
 	if (WARN_ON(ret))
 		dev_err(child->parent, "sdio read failed (%d)\n", ret);
 
+	if (unlikely(dump)) {
+		printk(KERN_DEBUG "wlcore_sdio: READ from 0x%04x\n", addr);
+		print_hex_dump(KERN_DEBUG, "wlcore_sdio: READ ",
+			       DUMP_PREFIX_OFFSET, 16, 1,
+			       buf, len, false);
+	}
+
 	return ret;
 }