ARM: dts: sun9i: a80-optimus: Order nodes by alphabetical order

Move the mmc nodes above the ohci nodes for proper ordering by name.
Signed-off-by: Chen-Yu Tsai <wens@csie.org>
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>

arch/arm/boot/dts/sun9i-a80-optimus.dts

@@ -119,6 +119,31 @@ &ehci2 {
 	status = "okay";
 };
 
+&mmc0 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&mmc0_pins>, <&mmc0_cd_pin_optimus>;
+	vmmc-supply = <&reg_dcdc1>;
+	bus-width = <4>;
+	cd-gpios = <&pio 7 18 GPIO_ACTIVE_HIGH>; /* PH8 */
+	cd-inverted;
+	status = "okay";
+};
+
+&mmc2 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&mmc2_8bit_pins>;
+	vmmc-supply = <&reg_dcdc1>;
+	bus-width = <8>;
+	non-removable;
+	cap-mmc-hw-reset;
+	status = "okay";
+};
+
+&mmc2_8bit_pins {
+	/* Increase drive strength for DDR modes */
+	allwinner,drive = <SUN4I_PINCTRL_40_MA>;
+};
+
 &ohci0 {
 	status = "okay";
 };
@@ -157,31 +182,6 @@ usb3_vbus_pin_optimus: usb3_vbus_pin@1 {
 	};
 };
 
-&mmc0 {
-	pinctrl-names = "default";
-	pinctrl-0 = <&mmc0_pins>, <&mmc0_cd_pin_optimus>;
-	vmmc-supply = <&reg_dcdc1>;
-	bus-width = <4>;
-	cd-gpios = <&pio 7 18 GPIO_ACTIVE_HIGH>; /* PH8 */
-	cd-inverted;
-	status = "okay";
-};
-
-&mmc2 {
-	pinctrl-names = "default";
-	pinctrl-0 = <&mmc2_8bit_pins>;
-	vmmc-supply = <&reg_dcdc1>;
-	bus-width = <8>;
-	non-removable;
-	cap-mmc-hw-reset;
-	status = "okay";
-};
-
-&mmc2_8bit_pins {
-	/* Increase drive strength for DDR modes */
-	allwinner,drive = <SUN4I_PINCTRL_40_MA>;
-};
-
 &r_ir {
 	status = "okay";
 };