ARM: cfa10049: Switch the chip select pin of the LCD controller

The early prototypes had the chip select pin for the LCD controller
wired on the GPIO 3-23, while the production run of the CFA-10049 have
this chip select on the GPIO 3-5.
Signed-off-by: Brian Lilly <brian@crystalfontz.com>
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>

arch/arm/boot/dts/imx28-cfa10049.dts

@@ -33,7 +33,7 @@ hog_pins_cfa10049: hog-10049@0 {
 						0x1163 /* MX28_PAD_LCD_D22__GPIO_1_22 */
 						0x1173 /* MX28_PAD_LCD_D22__GPIO_1_23 */
 						0x2153 /* MX28_PAD_SSP2_D5__GPIO_2_21 */
-						0x3173 /* MX28_PAD_LCD_RESET__GPIO_3_23 */
+						0x3053 /* MX28_PAD_AUART1_TX__GPIO_3_5 */
 					>;
 					fsl,drive-strength = <0>;
 					fsl,voltage = <1>;
@@ -265,7 +265,7 @@ spi2 {
 		gpio-sck = <&gpio2 16 0>;
 		gpio-mosi = <&gpio2 17 0>;
 		gpio-miso = <&gpio2 18 0>;
-		cs-gpios = <&gpio3 23 0>;
+		cs-gpios = <&gpio3 5 0>;
 		num-chipselects = <1>;
 		#address-cells = <1>;
 		#size-cells = <0>;