drm/i915/icl: Add power well support

Add the definition for ICL power wells and their mapping to power
domains. On ICL there are 3 power well control registers, we'll select
the correct one based on higher bits of the power well ID. The offset
for the control and status flags within this register is based on the
lower bits of the ID as on older platforms.

As the DC state programming is also the same as on old platforms we can
reuse the corresponding helpers. For this we mark here the DC-off power
well as shared among multiple platforms.

Other than the above the delta between old platforms and ICL:
- Pipe C has its own power well, so we can save some additional power in the
  pipe A+B and (non-eDP) pipe A configurations.
- Power wells for port E/F DDI/AUX IO and Thunderbolt 1-4 AUX IO

v2:
- Rebase on drm-tip after prep patch for this was merged there as
  requested by Paulo.
- Actually add the new AUX and DDI power well control regs (Rakshmi)

v3:
- Fix power well register names in code comments
- Add TBT AUX->power well 3 dependency

v4:
- Rebase

v5:
- Detach AUX power wells from the INIT power domain. These power wells
  can only be enabled in a TC/TBT connected state and otherwise not
  needed during driver initialization.

v6:
- Use _MMIO_PORT(...) instead _MMIO(_PICK(...)) (Paulo)
  Fix checkpatch warnings.

Cc: Animesh Manna <animesh.manna@intel.com>
Cc: Rakshmi Bhatia <rakshmi.bhatia@intel.com>
Cc: Paulo Zanoni <paulo.r.zanoni@intel.com>
Signed-off-by: Imre Deak <imre.deak@intel.com>
Reviewed-by: Animesh Manna <animesh.manna@intel.com> (v1)
Reviewed-by: Paulo Zanoni <paulo.r.zanoni@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20180626142232.22361-1-imre.deak@intel.com

drivers/gpu/drm/i915/i915_reg.h

@@ -1045,13 +1045,13 @@ enum i915_power_well_id {
 
 	/*
 	 * HSW/BDW
-	 *  - HSW_PWR_WELL_CTL_DRIVER(0) (status bit: id*2, req bit: id*2+1)
+	 *  - _HSW_PWR_WELL_CTL1-4 (status bit: id*2, req bit: id*2+1)
 	 */
 	HSW_DISP_PW_GLOBAL = 15,
 
 	/*
 	 * GEN9+
-	 *  - HSW_PWR_WELL_CTL_DRIVER(0) (status bit: id*2, req bit: id*2+1)
+	 *  - _HSW_PWR_WELL_CTL1-4 (status bit: id*2, req bit: id*2+1)
 	 */
 	SKL_DISP_PW_MISC_IO = 0,
 	SKL_DISP_PW_DDI_A_E,
@@ -1075,17 +1075,54 @@ enum i915_power_well_id {
 	SKL_DISP_PW_2,
 
 	/* - custom power wells */
-	SKL_DISP_PW_DC_OFF,
 	BXT_DPIO_CMN_A,
 	BXT_DPIO_CMN_BC,
-	GLK_DPIO_CMN_C,			/* 19 */
+	GLK_DPIO_CMN_C,			/* 18 */
+
+	/*
+	 * GEN11+
+	 *  - _HSW_PWR_WELL_CTL1-4
+	 *    (status bit: (id&15)*2, req bit:(id&15)*2+1)
+	 */
+	ICL_DISP_PW_1 = 0,
+	ICL_DISP_PW_2,
+	ICL_DISP_PW_3,
+	ICL_DISP_PW_4,
+
+	/*
+	 *  - _HSW_PWR_WELL_CTL_AUX1/2/4
+	 *    (status bit: (id&15)*2, req bit:(id&15)*2+1)
+	 */
+	ICL_DISP_PW_AUX_A = 16,
+	ICL_DISP_PW_AUX_B,
+	ICL_DISP_PW_AUX_C,
+	ICL_DISP_PW_AUX_D,
+	ICL_DISP_PW_AUX_E,
+	ICL_DISP_PW_AUX_F,
+
+	ICL_DISP_PW_AUX_TBT1 = 24,
+	ICL_DISP_PW_AUX_TBT2,
+	ICL_DISP_PW_AUX_TBT3,
+	ICL_DISP_PW_AUX_TBT4,
+
+	/*
+	 *  - _HSW_PWR_WELL_CTL_DDI1/2/4
+	 *    (status bit: (id&15)*2, req bit:(id&15)*2+1)
+	 */
+	ICL_DISP_PW_DDI_A = 32,
+	ICL_DISP_PW_DDI_B,
+	ICL_DISP_PW_DDI_C,
+	ICL_DISP_PW_DDI_D,
+	ICL_DISP_PW_DDI_E,
+	ICL_DISP_PW_DDI_F,                      /* 37 */
 
 	/*
 	 * Multiple platforms.
 	 * Must start following the highest ID of any platform.
 	 * - custom power wells
 	 */
-	I915_DISP_PW_ALWAYS_ON = 20,
+	SKL_DISP_PW_DC_OFF = 38,
+	I915_DISP_PW_ALWAYS_ON,
 };
 
 #define PUNIT_REG_PWRGT_CTRL			0x60
@@ -1679,6 +1716,13 @@ enum i915_power_well_id {
 #define   IREF1RC_OFFSET_MASK		(0xFF << IREF1RC_OFFSET_SHIFT)
 #define BXT_PORT_CL1CM_DW10(phy)	_BXT_PHY((phy), _PORT_CL1CM_DW10_BC)
 
+#define _ICL_PORT_CL_DW12_A		0x162030
+#define _ICL_PORT_CL_DW12_B		0x6C030
+#define   ICL_LANE_ENABLE_AUX		(1 << 0)
+#define ICL_PORT_CL_DW12(port)		_MMIO_PORT((port),		\
+						   _ICL_PORT_CL_DW12_A, \
+						   _ICL_PORT_CL_DW12_B)
+
 #define _PORT_CL1CM_DW28_A		0x162070
 #define _PORT_CL1CM_DW28_BC		0x6C070
 #define   OCL1_POWER_DOWN_EN		(1 << 23)
@@ -8564,6 +8608,14 @@ enum {
 #define _HSW_PWR_WELL_CTL3			0x45408
 #define _HSW_PWR_WELL_CTL4			0x4540C
 
+#define _ICL_PWR_WELL_CTL_AUX1			0x45440
+#define _ICL_PWR_WELL_CTL_AUX2			0x45444
+#define _ICL_PWR_WELL_CTL_AUX4			0x4544C
+
+#define _ICL_PWR_WELL_CTL_DDI1			0x45450
+#define _ICL_PWR_WELL_CTL_DDI2			0x45454
+#define _ICL_PWR_WELL_CTL_DDI4			0x4545C
+
 /*
  * Each power well control register contains up to 16 (request, status) HW
  * flag tuples. The register index and HW flag shift is determined by the
@@ -8573,14 +8625,20 @@ enum {
  */
 #define _HSW_PW_REG_IDX(pw)			((pw) >> 4)
 #define _HSW_PW_SHIFT(pw)			(((pw) & 0xf) * 2)
-/* TODO: Add all PWR_WELL_CTL registers below for new platforms */
 #define HSW_PWR_WELL_CTL_BIOS(pw)	_MMIO(_PICK(_HSW_PW_REG_IDX(pw),       \
-						    _HSW_PWR_WELL_CTL1))
+						    _HSW_PWR_WELL_CTL1,	       \
+						    _ICL_PWR_WELL_CTL_AUX1,    \
+						    _ICL_PWR_WELL_CTL_DDI1))
 #define HSW_PWR_WELL_CTL_DRIVER(pw)	_MMIO(_PICK(_HSW_PW_REG_IDX(pw),       \
-						    _HSW_PWR_WELL_CTL2))
+						    _HSW_PWR_WELL_CTL2,	       \
+						    _ICL_PWR_WELL_CTL_AUX2,    \
+						    _ICL_PWR_WELL_CTL_DDI2))
+/* KVMR doesn't have a reg for AUX or DDI power well control */
 #define HSW_PWR_WELL_CTL_KVMR		_MMIO(_HSW_PWR_WELL_CTL3)
 #define HSW_PWR_WELL_CTL_DEBUG(pw)	_MMIO(_PICK(_HSW_PW_REG_IDX(pw),       \
-						    _HSW_PWR_WELL_CTL4))
+						    _HSW_PWR_WELL_CTL4,	       \
+						    _ICL_PWR_WELL_CTL_AUX4,    \
+						    _ICL_PWR_WELL_CTL_DDI4))
 
 #define   HSW_PWR_WELL_CTL_REQ(pw)		(1 << (_HSW_PW_SHIFT(pw) + 1))
 #define   HSW_PWR_WELL_CTL_STATE(pw)		(1 << _HSW_PW_SHIFT(pw))
@@ -8601,6 +8659,8 @@ enum skl_power_gate {
 #define  SKL_FUSE_DOWNLOAD_STATUS		(1 << 31)
 /* PG0 (HW control->no power well ID), PG1..PG2 (SKL_DISP_PW1..SKL_DISP_PW2) */
 #define  SKL_PW_TO_PG(pw)			((pw) - SKL_DISP_PW_1 + SKL_PG1)
+/* PG0 (HW control->no power well ID), PG1..PG4 (ICL_DISP_PW1..ICL_DISP_PW4) */
+#define  ICL_PW_TO_PG(pw)			((pw) - ICL_DISP_PW_1 + SKL_PG1)
 #define  SKL_FUSE_PG_DIST_STATUS(pg)		(1 << (27 - (pg)))
 
 #define _CNL_AUX_REG_IDX(pw)		((pw) - 9)

drivers/gpu/drm/i915/intel_display.h

@@ -199,6 +199,10 @@ enum intel_display_power_domain {
 	POWER_DOMAIN_AUX_E,
 	POWER_DOMAIN_AUX_F,
 	POWER_DOMAIN_AUX_IO_A,
+	POWER_DOMAIN_AUX_TBT1,
+	POWER_DOMAIN_AUX_TBT2,
+	POWER_DOMAIN_AUX_TBT3,
+	POWER_DOMAIN_AUX_TBT4,
 	POWER_DOMAIN_GMBUS,
 	POWER_DOMAIN_MODESET,
 	POWER_DOMAIN_GT_IRQ,