ARM: tegra: roth: fix unsupported pinmux properties

The pinmux subsystem complained that the nvidia,low-power-mode property
is not supported by the sdio1, sdio3 and gma drive groups. In addition
gma also does not support nvidia,drive-type. Remove these properties so
the pinmux configuration can properly be applied.
Signed-off-by: Alexandre Courbot <acourbot@nvidia.com>
Signed-off-by: Stephen Warren <swarren@nvidia.com>

arch/arm/boot/dts/tegra114-roth.dts

@@ -730,7 +730,6 @@ drive_sdio1 {
 				nvidia,pins = "drive_sdio1";
 				nvidia,high-speed-mode = <TEGRA_PIN_ENABLE>;
 				nvidia,schmitt = <TEGRA_PIN_DISABLE>;
-				nvidia,low-power-mode = <TEGRA_PIN_LP_DRIVE_DIV_1>;
 				nvidia,pull-down-strength = <36>;
 				nvidia,pull-up-strength = <20>;
 				nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_SLOW>;
@@ -740,7 +739,6 @@ drive_sdio3 {
 				nvidia,pins = "drive_sdio3";
 				nvidia,high-speed-mode = <TEGRA_PIN_ENABLE>;
 				nvidia,schmitt = <TEGRA_PIN_DISABLE>;
-				nvidia,low-power-mode = <TEGRA_PIN_LP_DRIVE_DIV_1>;
 				nvidia,pull-down-strength = <36>;
 				nvidia,pull-up-strength = <20>;
 				nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
@@ -750,12 +748,10 @@ drive_gma {
 				nvidia,pins = "drive_gma";
 				nvidia,high-speed-mode = <TEGRA_PIN_ENABLE>;
 				nvidia,schmitt = <TEGRA_PIN_DISABLE>;
-				nvidia,low-power-mode = <TEGRA_PIN_LP_DRIVE_DIV_1>;
 				nvidia,pull-down-strength = <2>;
 				nvidia,pull-up-strength = <2>;
 				nvidia,slew-rate-rising = <TEGRA_PIN_SLEW_RATE_FASTEST>;
 				nvidia,slew-rate-falling = <TEGRA_PIN_SLEW_RATE_FASTEST>;
-				nvidia,drive-type = <1>;
 			};
 		};
 	};