[PATCH] md: Don't clear bits in bitmap when writing to one device fails during recovery

Currently a device failure during recovery leaves bits set in the bitmap.
This normally isn't a problem as the offending device will be rejected because
of errors.  However if device re-adding is being used with non-persistent
bitmaps, this can be a problem.
Signed-off-by: Neil Brown <neilb@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

drivers/md/raid1.c

@@ -1135,8 +1135,19 @@ static int end_sync_write(struct bio *bio, unsigned int bytes_done, int error)
 			mirror = i;
 			break;
 		}
-	if (!uptodate)
+	if (!uptodate) {
+		int sync_blocks = 0;
+		sector_t s = r1_bio->sector;
+		long sectors_to_go = r1_bio->sectors;
+		/* make sure these bits doesn't get cleared. */
+		do {
+			bitmap_end_sync(mddev->bitmap, r1_bio->sector,
+					&sync_blocks, 1);
+			s += sync_blocks;
+			sectors_to_go -= sync_blocks;
+		} while (sectors_to_go > 0);
 		md_error(mddev, conf->mirrors[mirror].rdev);
+	}
 
 	update_head_pos(mirror, r1_bio);