rsi: handle BT traffic in driver

BT frames are passed through coex and hal modules to BUS.
After firmware is loaded, based on the operating mode CARD
READY frame comes for each protocol. When BT card ready is
received, BT attach is called.
Protocol operations are exchanged between the modules
at initialization time.
Build flag CONFIG_RSI_COEX is introduced to enable coex support
if CONFIG_BT_RSIHCI is enabled. Coex operations are valid if
coex mode is greater than 1 only.
Signed-off-by: Siva Rebbagondla <siva.rebbagondla@redpinesignals.com>
Signed-off-by: Prameela Rani Garnepudi <prameela.j04cs@gmail.com>
Signed-off-by: Amitkumar Karwar <amit.karwar@redpinesignals.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/rsi/rsi_91x_coex.c

@@ -43,8 +43,10 @@ static void rsi_coex_sched_tx_pkts(struct rsi_coex_ctrl_block *coex_cb)
 		coex_q = rsi_coex_determine_coex_q(coex_cb);
 		rsi_dbg(INFO_ZONE, "queue = %d\n", coex_q);
 
-		if (coex_q == RSI_COEX_Q_BT)
+		if (coex_q == RSI_COEX_Q_BT) {
 			skb = skb_dequeue(&coex_cb->coex_tx_qs[RSI_COEX_Q_BT]);
+			rsi_send_bt_pkt(coex_cb->priv, skb);
+		}
 	} while (coex_q != RSI_COEX_Q_INVALID);
 }
 

drivers/net/wireless/rsi/rsi_91x_core.c

@@ -17,6 +17,7 @@
 #include "rsi_mgmt.h"
 #include "rsi_common.h"
 #include "rsi_hal.h"
+#include "rsi_coex.h"
 
 /**
  * rsi_determine_min_weight_queue() - This function determines the queue with
@@ -301,14 +302,23 @@ void rsi_core_qos_processor(struct rsi_common *common)
 			mutex_unlock(&common->tx_lock);
 			break;
 		}
-
-		if (q_num == MGMT_SOFT_Q) {
-			status = rsi_send_mgmt_pkt(common, skb);
-		} else if (q_num == MGMT_BEACON_Q) {
+		if (q_num == MGMT_BEACON_Q) {
 			status = rsi_send_pkt_to_bus(common, skb);
 			dev_kfree_skb(skb);
 		} else {
-			status = rsi_send_data_pkt(common, skb);
+#ifdef CONFIG_RSI_COEX
+			if (common->coex_mode > 1) {
+				status = rsi_coex_send_pkt(common, skb,
+							   RSI_WLAN_Q);
+			} else {
+#endif
+				if (q_num == MGMT_SOFT_Q)
+					status = rsi_send_mgmt_pkt(common, skb);
+				else
+					status = rsi_send_data_pkt(common, skb);
+#ifdef CONFIG_RSI_COEX
+			}
+#endif
 		}
 
 		if (status) {

drivers/net/wireless/rsi/rsi_91x_hal.c

@@ -15,6 +15,7 @@
  */
 
 #include <linux/firmware.h>
+#include <net/bluetooth/bluetooth.h>
 #include "rsi_mgmt.h"
 #include "rsi_hal.h"
 #include "rsi_sdio.h"
@@ -24,6 +25,7 @@
 static struct ta_metadata metadata_flash_content[] = {
 	{"flash_content", 0x00010000},
 	{"rsi/rs9113_wlan_qspi.rps", 0x00010000},
+	{"rsi/rs9113_wlan_bt_dual_mode.rps", 0x00010000},
 };
 
 int rsi_send_pkt_to_bus(struct rsi_common *common, struct sk_buff *skb)
@@ -357,6 +359,43 @@ int rsi_send_mgmt_pkt(struct rsi_common *common,
 	return status;
 }
 
+int rsi_send_bt_pkt(struct rsi_common *common, struct sk_buff *skb)
+{
+	int status = -EINVAL;
+	u8 header_size = 0;
+	struct rsi_bt_desc *bt_desc;
+	u8 queueno = ((skb->data[1] >> 4) & 0xf);
+
+	if (queueno == RSI_BT_MGMT_Q) {
+		status = rsi_send_pkt_to_bus(common, skb);
+		if (status)
+			rsi_dbg(ERR_ZONE, "%s: Failed to write bt mgmt pkt\n",
+				__func__);
+		goto out;
+	}
+	header_size = FRAME_DESC_SZ;
+	if (header_size > skb_headroom(skb)) {
+		rsi_dbg(ERR_ZONE, "%s: Not enough headroom\n", __func__);
+		status = -ENOSPC;
+		goto out;
+	}
+	skb_push(skb, header_size);
+	memset(skb->data, 0, header_size);
+	bt_desc = (struct rsi_bt_desc *)skb->data;
+
+	rsi_set_len_qno(&bt_desc->len_qno, (skb->len - FRAME_DESC_SZ),
+			RSI_BT_DATA_Q);
+	bt_desc->bt_pkt_type = cpu_to_le16(bt_cb(skb)->pkt_type);
+
+	status = rsi_send_pkt_to_bus(common, skb);
+	if (status)
+		rsi_dbg(ERR_ZONE, "%s: Failed to write bt pkt\n", __func__);
+
+out:
+	dev_kfree_skb(skb);
+	return status;
+}
+
 int rsi_prepare_beacon(struct rsi_common *common, struct sk_buff *skb)
 {
 	struct rsi_hw *adapter = (struct rsi_hw *)common->priv;

drivers/net/wireless/rsi/rsi_91x_main.c

@@ -18,6 +18,7 @@
 
 #include <linux/module.h>
 #include <linux/firmware.h>
+#include <net/rsi_91x.h>
 #include "rsi_mgmt.h"
 #include "rsi_common.h"
 #include "rsi_coex.h"
@@ -35,6 +36,14 @@ u32 rsi_zone_enabled = /* INFO_ZONE |
 			0;
 EXPORT_SYMBOL_GPL(rsi_zone_enabled);
 
+#ifdef CONFIG_RSI_COEX
+static struct rsi_proto_ops g_proto_ops = {
+	.coex_send_pkt = rsi_coex_send_pkt,
+	.get_host_intf = rsi_get_host_intf,
+	.set_bt_context = rsi_set_bt_context,
+};
+#endif
+
 /**
  * rsi_dbg() - This function outputs informational messages.
  * @zone: Zone of interest for output message.
@@ -144,6 +153,9 @@ int rsi_read_pkt(struct rsi_common *common, u8 *rx_pkt, s32 rcv_pkt_len)
 	u32 index, length = 0, queueno = 0;
 	u16 actual_length = 0, offset;
 	struct sk_buff *skb = NULL;
+#ifdef CONFIG_RSI_COEX
+	u8 bt_pkt_type;
+#endif
 
 	index = 0;
 	do {
@@ -185,6 +197,25 @@ int rsi_read_pkt(struct rsi_common *common, u8 *rx_pkt, s32 rcv_pkt_len)
 			rsi_mgmt_pkt_recv(common, (frame_desc + offset));
 			break;
 
+#ifdef CONFIG_RSI_COEX
+		case RSI_BT_MGMT_Q:
+		case RSI_BT_DATA_Q:
+#define BT_RX_PKT_TYPE_OFST	14
+#define BT_CARD_READY_IND	0x89
+			bt_pkt_type = frame_desc[offset + BT_RX_PKT_TYPE_OFST];
+			if (bt_pkt_type == BT_CARD_READY_IND) {
+				rsi_dbg(INFO_ZONE, "BT Card ready recvd\n");
+				if (rsi_bt_ops.attach(common, &g_proto_ops))
+					rsi_dbg(ERR_ZONE,
+						"Failed to attach BT module\n");
+			} else {
+				if (common->bt_adapter)
+					rsi_bt_ops.recv_pkt(common->bt_adapter,
+							frame_desc + offset);
+			}
+			break;
+#endif
+
 		default:
 			rsi_dbg(ERR_ZONE, "%s: pkt from invalid queue: %d\n",
 				__func__,   queueno);
@@ -232,6 +263,13 @@ enum rsi_host_intf rsi_get_host_intf(void *priv)
 
 	return common->priv->rsi_host_intf;
 }
+
+void rsi_set_bt_context(void *priv, void *bt_context)
+{
+	struct rsi_common *common = (struct rsi_common *)priv;
+
+	common->bt_adapter = bt_context;
+}
 #endif
 
 /**
@@ -323,13 +361,18 @@ void rsi_91x_deinit(struct rsi_hw *adapter)
 	for (ii = 0; ii < NUM_SOFT_QUEUES; ii++)
 		skb_queue_purge(&common->tx_queue[ii]);
 
-	common->init_done = false;
-
 #ifdef CONFIG_RSI_COEX
-	if (common->coex_mode > 1)
+	if (common->coex_mode > 1) {
+		if (common->bt_adapter) {
+			rsi_bt_ops.detach(common->bt_adapter);
+			common->bt_adapter = NULL;
+		}
 		rsi_coex_detach(common);
+	}
 #endif
 
+	common->init_done = false;
+
 	kfree(common);
 	kfree(adapter->rsi_dev);
 	kfree(adapter);

drivers/net/wireless/rsi/rsi_91x_sdio_ops.c

@@ -16,6 +16,7 @@
  */
 
 #include <linux/firmware.h>
+#include <net/rsi_91x.h>
 #include "rsi_sdio.h"
 #include "rsi_common.h"
 

drivers/net/wireless/rsi/rsi_common.h

@@ -62,6 +62,7 @@ static inline int rsi_create_kthread(struct rsi_common *common,
 				     u8 *name)
 {
 	init_completion(&thread->completion);
+	atomic_set(&thread->thread_done, 0);
 	thread->task = kthread_run(func_ptr, common, "%s", name);
 	if (IS_ERR(thread->task))
 		return (int)PTR_ERR(thread->task);

drivers/net/wireless/rsi/rsi_hal.h

@@ -145,8 +145,18 @@ struct rsi_data_desc {
 	u8 sta_id;
 } __packed;
 
+struct rsi_bt_desc {
+	__le16 len_qno;
+	__le16 reserved1;
+	__le32 reserved2;
+	__le32 reserved3;
+	__le16 reserved4;
+	__le16 bt_pkt_type;
+} __packed;
+
 int rsi_hal_device_init(struct rsi_hw *adapter);
 int rsi_prepare_beacon(struct rsi_common *common, struct sk_buff *skb);
 int rsi_send_pkt_to_bus(struct rsi_common *common, struct sk_buff *skb);
+int rsi_send_bt_pkt(struct rsi_common *common, struct sk_buff *skb);
 
 #endif

drivers/net/wireless/rsi/rsi_main.h

@@ -291,6 +291,8 @@ struct rsi_common {
 	bool p2p_enabled;
 	struct timer_list roc_timer;
 	struct ieee80211_vif *roc_vif;
+
+	void *bt_adapter;
 };
 
 struct eepromrw_info {
@@ -364,5 +366,6 @@ struct rsi_host_intf_ops {
 };
 
 enum rsi_host_intf rsi_get_host_intf(void *priv);
+void rsi_set_bt_context(void *priv, void *bt_context);
 
 #endif