[PATCH] USB: AX8817X Driver for 2.5

drivers/usb/Makefile.lib

+obj-$(CONFIG_USB_AX8817X)	+= crc32.o
 obj-$(CONFIG_USB_CATC)		+= crc32.o
 obj-$(CONFIG_USB_SPEEDTOUCH)	+= crc32.o
 obj-$(CONFIG_USB_USBNET)	+= crc32.o

drivers/usb/net/Kconfig

@@ -7,6 +7,27 @@ comment "USB Network adaptors"
 comment "Networking support is needed for USB Networking device support"
 	depends on USB && !NET
 
+config USB_AX8817X
+	tristate "USB ASIX AX8817X Ethernet device support (EXPERIMENTAL)"
+	depends on USB && NET && EXPERIMENTAL
+	---help---
+	  Say Y if you want to use one of the following 10/100Mps USB
+	  Ethernet devices based on the ASIX AX88172 chip.  Supported
+	  devices are:
+		ASIX AX88172
+		D-Link DUB-E100
+		Hawking UF200
+		Netgear FA120
+
+	  This driver makes the adapter appear as a normal Ethernet interface,
+	  typically on eth0, if it is the only ethernet device, or perhaps on
+	  eth1, if you have a PCI or ISA ethernet card installed.
+
+	  This code is also available as a module ( = code which can be
+	  inserted in and removed from the running kernel whenever you want).
+	  The module will be called ax8817x.o. If you want to compile it as a
+	  module, say M here and read <file:Documentation/modules.txt>.
+
 config USB_CATC
 	tristate "USB CATC NetMate-based Ethernet device support (EXPERIMENTAL)"
 	depends on USB && NET && EXPERIMENTAL

drivers/usb/net/Makefile

@@ -2,6 +2,7 @@
 # Makefile for USB Network drivers
 #
 
+obj-$(CONFIG_USB_AX8817X)	+= ax8817x.o
 obj-$(CONFIG_USB_CATC)		+= catc.o
 obj-$(CONFIG_USB_KAWETH)	+= kaweth.o
 obj-$(CONFIG_USB_PEGASUS)	+= pegasus.o

drivers/usb/net/Makefile.mii

@@ -2,4 +2,5 @@
 # Makefile for USB Network drivers which require generic MII code.
 #
 
+obj-$(CONFIG_USB_AX8817X)	+= mii.o
 obj-$(CONFIG_USB_PEGASUS)	+= mii.o