Commit 74072bae authored by Mathias Nyman's avatar Mathias Nyman Committed by Greg Kroah-Hartman

usb: Increase root hub reset signaling time to prevent retry

Save 80ms device enumeration time by increasing root hub port reset time

The 50ms reset signaling time is not enough for most root hub ports.
Increasing the reset time to 60ms allows host controllers to finish port
reset and removes a retry causing an extra 50ms delay.

The USB 2 specification requires "at least 50ms" for driving root
port reset. The current msleep is exactly 50ms which may not be
enough if there are any delays between writing the reset bit to host
controller portsc register and phy actually driving reset.

On Haswell, Skylake and Kabylake xHC port reset took in average 52-59ms

The 80ms improvement comes from (40ms * 2 port resets) save at enumeration
for each device connected to a root hub port.

more details about root port reset in USB2 section 7.1.7.5:.
"Software must ensure that resets issued to the root ports drive reset
long enough to overwhelm any concurrent resume attempts by downstream
devices. It is required that resets from root ports have a duration of
at least 50 ms (TDRSTR).
Signed-off-by: default avatarMathias Nyman <mathias.nyman@linux.intel.com>
Acked-by: default avatarAlan Stern <stern@rowland.harvard.edu>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 8ca1358b
...@@ -2614,7 +2614,7 @@ static unsigned hub_is_wusb(struct usb_hub *hub) ...@@ -2614,7 +2614,7 @@ static unsigned hub_is_wusb(struct usb_hub *hub)
#define SET_CONFIG_TRIES (2 * (use_both_schemes + 1)) #define SET_CONFIG_TRIES (2 * (use_both_schemes + 1))
#define USE_NEW_SCHEME(i) ((i) / 2 == (int)old_scheme_first) #define USE_NEW_SCHEME(i) ((i) / 2 == (int)old_scheme_first)
#define HUB_ROOT_RESET_TIME 50 /* times are in msec */ #define HUB_ROOT_RESET_TIME 60 /* times are in msec */
#define HUB_SHORT_RESET_TIME 10 #define HUB_SHORT_RESET_TIME 10
#define HUB_BH_RESET_TIME 50 #define HUB_BH_RESET_TIME 50
#define HUB_LONG_RESET_TIME 200 #define HUB_LONG_RESET_TIME 200
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment