net: enetc: Use IRQF_NO_AUTOEN flag in request_irq()

disable_irq() after request_irq() still has a time gap in which
interrupts can come. request_irq() with IRQF_NO_AUTOEN flag will
disable IRQ auto-enable when request IRQ.

Fixes: bbb96dc7 ("enetc: Factor out the traffic start/stop procedures")
Signed-off-by: Jinjie Ruan <ruanjinjie@huawei.com>
Link: https://patch.msgid.link/20240911094445.1922476-3-ruanjinjie@huawei.comSigned-off-by: Jakub Kicinski <kuba@kernel.org>

drivers/net/ethernet/freescale/enetc/enetc.c

@@ -2305,12 +2305,11 @@ static int enetc_setup_irqs(struct enetc_ndev_priv *priv)
 
 		snprintf(v->name, sizeof(v->name), "%s-rxtx%d",
 			 priv->ndev->name, i);
-		err = request_irq(irq, enetc_msix, 0, v->name, v);
+		err = request_irq(irq, enetc_msix, IRQF_NO_AUTOEN, v->name, v);
 		if (err) {
 			dev_err(priv->dev, "request_irq() failed!\n");
 			goto irq_err;
 		}
-		disable_irq(irq);
 
 		v->tbier_base = hw->reg + ENETC_BDR(TX, 0, ENETC_TBIER);
 		v->rbier = hw->reg + ENETC_BDR(RX, i, ENETC_RBIER);