Commit 7a53f3f3 authored by Michal Kazior's avatar Michal Kazior Committed by Kalle Valo

ath10k: clean up monitor start code

Remove useless code that was causing WARN_ON when
a 80MHz+ vif entered promiscuous mode or monitor
interface was started.

The channel mode is already computed by
chan_to_phymode().
Signed-off-by: default avatarMichal Kazior <michal.kazior@tieto.com>
Signed-off-by: default avatarKalle Valo <kvalo@qca.qualcomm.com>
parent 9c5ae691
......@@ -503,13 +503,10 @@ static int ath10k_monitor_start(struct ath10k *ar, int vdev_id)
{
struct ieee80211_channel *channel = ar->hw->conf.chandef.chan;
struct wmi_vdev_start_request_arg arg = {};
enum nl80211_channel_type type;
int ret = 0;
lockdep_assert_held(&ar->conf_mutex);
type = cfg80211_get_chandef_type(&ar->hw->conf.chandef);
arg.vdev_id = vdev_id;
arg.channel.freq = channel->center_freq;
arg.channel.band_center_freq1 = ar->hw->conf.chandef.center_freq1;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment