Commit 7ad09458 authored by Somnath kotur's avatar Somnath kotur Committed by David S. Miller

be2net: clear promiscuous bits in adapter->flags while disabling promiscuous mode

We should clear promiscuous bits in adapter->flags while disabling promiscuous
mode. Else we will not put interface back into VLAN promisc mode if the vlans
already added exceeds the maximum limit.
Signed-off-by: default avatarKalesh AP <kalesh.purayil@emulex.com>
Signed-off-by: default avatarSomnath Kotur <somnath.kotur@emulex.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent c502224e
......@@ -1157,6 +1157,14 @@ static int be_vlan_rem_vid(struct net_device *netdev, __be16 proto, u16 vid)
return status;
}
static void be_clear_promisc(struct be_adapter *adapter)
{
adapter->promiscuous = false;
adapter->flags &= ~BE_FLAGS_VLAN_PROMISC;
be_cmd_rx_filter(adapter, IFF_PROMISC, OFF);
}
static void be_set_rx_mode(struct net_device *netdev)
{
struct be_adapter *adapter = netdev_priv(netdev);
......@@ -1170,9 +1178,7 @@ static void be_set_rx_mode(struct net_device *netdev)
/* BE was previously in promiscuous mode; disable it */
if (adapter->promiscuous) {
adapter->promiscuous = false;
be_cmd_rx_filter(adapter, IFF_PROMISC, OFF);
be_clear_promisc(adapter);
if (adapter->vlans_added)
be_vid_config(adapter);
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment