tty: serial: imx: don't reinit clock in imx_setup_ufcr()

Remove the clock configuration from imx_setup_ufcr(). This
isn't needed here and will cause garbage output if done.

To be be sure that we only touch the bits we want (TXTL and RXTL)
we have to mask out all other bits of the UFCR register. Add
one non-existing bit macro for this, too (bit 6, DCEDTE on i.MX6).
Signed-off-by: Dirk Behme <dirk.behme@de.bosch.com>
CC: Shawn Guo <shawn.guo@linaro.org>
CC: Sascha Hauer <s.hauer@pengutronix.de>
CC: Troy Kisky <troy.kisky@boundarydevices.com>
CC: Xinyu Chen <xinyu.chen@freescale.com>
Cc: stable <stable@vger.kernel.org>
Acked-by: Shawn Guo <shawn.guo@linaro.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/imx.c

@@ -132,6 +132,7 @@
 #define  UCR4_OREN  	 (1<<1)  /* Receiver overrun interrupt enable */
 #define  UCR4_DREN  	 (1<<0)  /* Recv data ready interrupt enable */
 #define  UFCR_RXTL_SHF   0       /* Receiver trigger level shift */
+#define  UFCR_DCEDTE	 (1<<6)  /* DCE/DTE mode select */
 #define  UFCR_RFDIV      (7<<7)  /* Reference freq divider mask */
 #define  UFCR_RFDIV_REG(x)	(((x) < 7 ? 6 - (x) : 6) << 7)
 #define  UFCR_TXTL_SHF   10      /* Transmitter trigger level shift */
@@ -667,22 +668,11 @@ static void imx_break_ctl(struct uart_port *port, int break_state)
 static int imx_setup_ufcr(struct imx_port *sport, unsigned int mode)
 {
 	unsigned int val;
-	unsigned int ufcr_rfdiv;
-
-	/* set receiver / transmitter trigger level.
-	 * RFDIV is set such way to satisfy requested uartclk value
-	 */
-	val = TXTL << 10 | RXTL;
-	ufcr_rfdiv = (clk_get_rate(sport->clk_per) + sport->port.uartclk / 2)
-			/ sport->port.uartclk;
-
-	if(!ufcr_rfdiv)
-		ufcr_rfdiv = 1;
-
-	val |= UFCR_RFDIV_REG(ufcr_rfdiv);
 
+	/* set receiver / transmitter trigger level */
+	val = readl(sport->port.membase + UFCR) & (UFCR_RFDIV | UFCR_DCEDTE);
+	val |= TXTL << UFCR_TXTL_SHF | RXTL;
 	writel(val, sport->port.membase + UFCR);
-
 	return 0;
 }