net: phy: call phy_disable_interrupts() in phy_attach_direct() instead

Since the micrel phy driver calls phy_init_hw() as a workaround,
the commit 9886a4db ("net: phy: call phy_disable_interrupts()
in phy_init_hw()") disables the interrupt unexpectedly. So,
call phy_disable_interrupts() in phy_attach_direct() instead.
Otherwise, the phy cannot link up after the ethernet cable was
disconnected.

Note that other drivers (like at803x.c) also calls phy_init_hw().
So, perhaps, the driver caused a similar issue too.

Fixes: 9886a4db ("net: phy: call phy_disable_interrupts() in phy_init_hw()")
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/phy/phy_device.c

@@ -1143,10 +1143,6 @@ int phy_init_hw(struct phy_device *phydev)
 	if (ret < 0)
 		return ret;
 
-	ret = phy_disable_interrupts(phydev);
-	if (ret)
-		return ret;
-
 	if (phydev->drv->config_init)
 		ret = phydev->drv->config_init(phydev);
 
@@ -1423,6 +1419,10 @@ int phy_attach_direct(struct net_device *dev, struct phy_device *phydev,
 	if (err)
 		goto error;
 
+	err = phy_disable_interrupts(phydev);
+	if (err)
+		return err;
+
 	phy_resume(phydev);
 	phy_led_triggers_register(phydev);