Commit 7d444522 authored by Alagu Sankar's avatar Alagu Sankar Committed by Kalle Valo

ath10k: don't report unset rssi values to mac80211

The SDIO firmware does not provide RSSI value to the host, it's only set to
zero. In that case don't report the value to mac80211. One risk here is that
value zero might be a valid value with other firmware, currently there's no way
to detect that.

Without the fix, the rssi value indicated by iw changes between the actual
value and -95.

Tested with QCA6174 SDIO with firmware WLAN.RMH.4.4.1-00005-QCARMSWP-1.
Co-developed-by: default avatarWen Gong <wgong@codeaurora.org>
Signed-off-by: default avatarAlagu Sankar <alagusankar@silex-india.com>
Signed-off-by: default avatarWen Gong <wgong@codeaurora.org>
Signed-off-by: default avatarKalle Valo <kvalo@codeaurora.org>
parent 55545b08
......@@ -2119,9 +2119,15 @@ static bool ath10k_htt_rx_proc_rx_ind_hl(struct ath10k_htt *htt,
hdr = (struct ieee80211_hdr *)skb->data;
rx_status = IEEE80211_SKB_RXCB(skb);
rx_status->chains |= BIT(0);
rx_status->signal = ATH10K_DEFAULT_NOISE_FLOOR +
rx->ppdu.combined_rssi;
rx_status->flag &= ~RX_FLAG_NO_SIGNAL_VAL;
if (rx->ppdu.combined_rssi == 0) {
/* SDIO firmware does not provide signal */
rx_status->signal = 0;
rx_status->flag |= RX_FLAG_NO_SIGNAL_VAL;
} else {
rx_status->signal = ATH10K_DEFAULT_NOISE_FLOOR +
rx->ppdu.combined_rssi;
rx_status->flag &= ~RX_FLAG_NO_SIGNAL_VAL;
}
spin_lock_bh(&ar->data_lock);
ch = ar->scan_channel;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment