Bluetooth: hci_qca: Set BDA quirk bit if fwnode exists in DT

BT adapter going into UNCONFIGURED state during BT turn ON when
devicetree has no local-bd-address node.

Bluetooth will not work out of the box on such devices, to avoid this
problem, added check to set HCI_QUIRK_USE_BDADDR_PROPERTY based on
local-bd-address node entry.

When this quirk is not set, the public Bluetooth address read by host
from controller though HCI Read BD Address command is
considered as valid.

Fixes: e668eb1e ("Bluetooth: hci_core: Don't stop BT if the BD address missing in dts")
Signed-off-by: Janaki Ramaiah Thota <quic_janathot@quicinc.com>
Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>

drivers/bluetooth/hci_qca.c

@@ -7,6 +7,7 @@
  *
  *  Copyright (C) 2007 Texas Instruments, Inc.
  *  Copyright (c) 2010, 2012, 2018 The Linux Foundation. All rights reserved.
+ *  Copyright (c) 2023 Qualcomm Innovation Center, Inc. All rights reserved.
  *
  *  Acknowledgements:
  *  This file is based on hci_ll.c, which was...
@@ -1904,7 +1905,17 @@ static int qca_setup(struct hci_uart *hu)
 	case QCA_WCN6750:
 	case QCA_WCN6855:
 	case QCA_WCN7850:
-		set_bit(HCI_QUIRK_USE_BDADDR_PROPERTY, &hdev->quirks);
+
+		/* Set BDA quirk bit for reading BDA value from fwnode property
+		 * only if that property exist in DT.
+		 */
+		if (fwnode_property_present(dev_fwnode(hdev->dev.parent), "local-bd-address")) {
+			set_bit(HCI_QUIRK_USE_BDADDR_PROPERTY, &hdev->quirks);
+			bt_dev_info(hdev, "setting quirk bit to read BDA from fwnode later");
+		} else {
+			bt_dev_dbg(hdev, "local-bd-address` is not present in the devicetree so not setting quirk bit for BDA");
+		}
+
 		hci_set_aosp_capable(hdev);
 
 		ret = qca_read_soc_version(hdev, &ver, soc_type);