arm64: dts: qcom: sc8280xp: remove superfluous "input-enable"

Pin configuration property "input-enable" was used with the intention to
disable the output, but this is done by default by Linux drivers.  Since
patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
input-enable") the property is not accepted anymore.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20230407175807.124394-5-krzysztof.kozlowski@linaro.org

arch/arm64/boot/dts/qcom/sc8280xp.dtsi

@@ -2726,7 +2726,6 @@ data-pins {
 					pins = "gpio7";
 					function = "dmic1_data";
 					drive-strength = <8>;
-					input-enable;
 				};
 			};
 
@@ -2744,7 +2743,6 @@ data-pins {
 					function = "dmic1_data";
 					drive-strength = <2>;
 					bias-pull-down;
-					input-enable;
 				};
 			};
 
@@ -2760,7 +2758,6 @@ data-pins {
 					pins = "gpio9";
 					function = "dmic2_data";
 					drive-strength = <8>;
-					input-enable;
 				};
 			};
 
@@ -2778,7 +2775,6 @@ data-pins {
 					function = "dmic2_data";
 					drive-strength = <2>;
 					bias-pull-down;
-					input-enable;
 				};
 			};