Commit 89a86da5 authored by Alexandru Tachici's avatar Alexandru Tachici Committed by Jonathan Cameron

iio: adc: ad7192: Add IRQ flag

IRQ type in ad_sigma_delta_info struct was missing.

In Sigma-Delta devices the SDO line is also used as an interrupt.
Leaving IRQ on level instead of falling might trigger a sample read
when the IRQ is enabled, as the SDO line is already low. Not sure
if SDO line will always immediately go high in ad_sd_buffer_postenable
before the IRQ is enabled.

Also the datasheet seem to explicitly say the falling edge of the SDO
should be used as an interrupt:
>From the AD7192 datasheet: "The DOUT/RDY falling edge can be used
as an interrupt to a processor,"

Fixes: da4d3d6b ("iio: adc: ad-sigma-delta: Allow custom IRQ flags")
Signed-off-by: default avatarAlexandru Tachici <alexandru.tachici@analog.com>
Cc: <Stable@vger.kernel.org>
Link: https://lore.kernel.org/r/20210906065630.16325-2-alexandru.tachici@analog.comSigned-off-by: default avatarJonathan Cameron <Jonathan.Cameron@huawei.com>
parent eb795cd9
...@@ -293,6 +293,7 @@ static const struct ad_sigma_delta_info ad7192_sigma_delta_info = { ...@@ -293,6 +293,7 @@ static const struct ad_sigma_delta_info ad7192_sigma_delta_info = {
.has_registers = true, .has_registers = true,
.addr_shift = 3, .addr_shift = 3,
.read_mask = BIT(6), .read_mask = BIT(6),
.irq_flags = IRQF_TRIGGER_FALLING,
}; };
static const struct ad_sd_calib_data ad7192_calib_arr[8] = { static const struct ad_sd_calib_data ad7192_calib_arr[8] = {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment