arm: dts: zynq: Move crystal freq. to board level

The fact that all supported boards use the same 33MHz crystal is a
co-incidence. The Zynq PS support a range of crystal freqs so the
hardcoded setting should be removed from the dtsi. Re-implement it
on the board level.

This prepares support for Zynq boards with different crystal
frequencies (e.g. the Digilent ZYBO).
Acked-by: Soren Brinkmann <soren.brinkmann@xilinx.com>
Signed-off-by: Peter Crosthwaite <crosthwaite.peter@gmail.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>

arch/arm/boot/dts/zynq-7000.dtsi

@@ -244,7 +244,6 @@ slcr: slcr@f8000000 {
 			clkc: clkc@100 {
 				#clock-cells = <1>;
 				compatible = "xlnx,ps7-clkc";
-				ps-clk-frequency = <33333333>;
 				fclk-enable = <0>;
 				clock-output-names = "armpll", "ddrpll", "iopll", "cpu_6or4x",
 						"cpu_3or2x", "cpu_2x", "cpu_1x", "ddr2x", "ddr3x",

arch/arm/boot/dts/zynq-parallella.dts

@@ -34,6 +34,10 @@ chosen {
 	};
 };
 
+&clkc {
+	ps-clk-frequency = <33333333>;
+};
+
 &gem0 {
 	status = "okay";
 	phy-mode = "rgmii-id";

arch/arm/boot/dts/zynq-zc702.dts

@@ -42,6 +42,10 @@ &can0 {
 	status = "okay";
 };
 
+&clkc {
+	ps-clk-frequency = <33333333>;
+};
+
 &gem0 {
 	status = "okay";
 	phy-mode = "rgmii-id";

arch/arm/boot/dts/zynq-zc706.dts

@@ -29,6 +29,10 @@ chosen {
 
 };
 
+&clkc {
+	ps-clk-frequency = <33333333>;
+};
+
 &gem0 {
 	status = "okay";
 	phy-mode = "rgmii-id";

arch/arm/boot/dts/zynq-zed.dts

@@ -29,6 +29,10 @@ chosen {
 
 };
 
+&clkc {
+	ps-clk-frequency = <33333333>;
+};
+
 &gem0 {
 	status = "okay";
 	phy-mode = "rgmii-id";