Commit 8cab02dc authored by Thomas Gleixner's avatar Thomas Gleixner

x86: Do not unregister PIT clocksource on PIT oneshot setup/shutdown

This basically reverts commit 1a0c009a (x86: unregister PIT
clocksource when PIT is disabled) because the problem which was tried
to address with that patch has been solved by commit 3f68535a
(clocksource: sanity check sysfs clocksource changes).

The problem addressed by the original patch is that PIT could be
selected as clocksource after the system switched the PIT off or set
the PIT into one shot mode which would result in complete timekeeping
wreckage.

Now with the sysfs sanity check in place PIT cannot be selected again
when the system is in oneshot mode. The system will not switch to one
shot mode as long as PIT is installed because PIT is not suitable for
one shot.

The shutdown case which happens when the lapic timer is installed is
covered by the fact that init_pit_clocksource() is called after the
lapic timer take over and then does not install the PIT clocksource
at all.

We should have done the sanity checks back then, but ...

This also solves the locking problem which was reported vs. the
clocksource rework.

LKML-Reference: <new-submission>
Cc: Martin Schwidefsky <schwidefsky@de.ibm.com>
Cc: john stultz <johnstul@us.ibm.com>
Signed-off-by: default avatarThomas Gleixner <tglx@linutronix.de>
parent 01548f4d
......@@ -19,12 +19,6 @@
DEFINE_SPINLOCK(i8253_lock);
EXPORT_SYMBOL(i8253_lock);
#ifdef CONFIG_X86_32
static void pit_disable_clocksource(void);
#else
static inline void pit_disable_clocksource(void) { }
#endif
/*
* HPET replaces the PIT, when enabled. So we need to know, which of
* the two timers is used
......@@ -57,12 +51,10 @@ static void init_pit_timer(enum clock_event_mode mode,
outb_pit(0, PIT_CH0);
outb_pit(0, PIT_CH0);
}
pit_disable_clocksource();
break;
case CLOCK_EVT_MODE_ONESHOT:
/* One shot setup */
pit_disable_clocksource();
outb_pit(0x38, PIT_MODE);
break;
......@@ -200,17 +192,6 @@ static struct clocksource pit_cs = {
.shift = 20,
};
static void pit_disable_clocksource(void)
{
/*
* Use mult to check whether it is registered or not
*/
if (pit_cs.mult) {
clocksource_unregister(&pit_cs);
pit_cs.mult = 0;
}
}
static int __init init_pit_clocksource(void)
{
/*
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment