net: qcom/emac: disable interrupts before calling phy_disconnect

There is a race condition that can occur if EMAC interrupts are
enabled when phy_disconnect() is called.  phy_disconnect() sets
adjust_link to NULL.  When an interrupt occurs, the ISR might
call phy_mac_interrupt(), which wakes up the workqueue function
phy_state_machine().  This function might reference adjust_link,
thereby causing a null pointer exception.
Signed-off-by: Timur Tabi <timur@codeaurora.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/qualcomm/emac/emac-mac.c

@@ -1021,14 +1021,18 @@ void emac_mac_down(struct emac_adapter *adpt)
 	napi_disable(&adpt->rx_q.napi);
 
 	phy_stop(adpt->phydev);
-	phy_disconnect(adpt->phydev);
 
-	/* disable mac irq */
+	/* Interrupts must be disabled before the PHY is disconnected, to
+	 * avoid a race condition where adjust_link is null when we get
+	 * an interrupt.
+	 */
 	writel(DIS_INT, adpt->base + EMAC_INT_STATUS);
 	writel(0, adpt->base + EMAC_INT_MASK);
 	synchronize_irq(adpt->irq.irq);
 	free_irq(adpt->irq.irq, &adpt->irq);
 
+	phy_disconnect(adpt->phydev);
+
 	emac_mac_reset(adpt);
 
 	emac_tx_q_descs_free(adpt);