Merge tag 'gpio-fixes-for-v6.10-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux

Pull gpio fixes from Bartosz Golaszewski:
 "Two OF lookup quirks and one fix for an issue in the generic gpio-mmio
  driver:

   - add two OF lookup quirks for TSC2005 and MIPS Lantiq

   - don't try to figure out bgpio_bits from the 'ngpios' property in
     gpio-mmio"

* tag 'gpio-fixes-for-v6.10-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux:
  gpiolib: of: add polarity quirk for TSC2005
  gpio: mmio: do not calculate bgpio_bits via "ngpios"
  gpiolib: of: fix lookup quirk for MIPS Lantiq

drivers/gpio/gpio-mmio.c

@@ -619,8 +619,6 @@ int bgpio_init(struct gpio_chip *gc, struct device *dev,
 	ret = gpiochip_get_ngpios(gc, dev);
 	if (ret)
 		gc->ngpio = gc->bgpio_bits;
-	else
-		gc->bgpio_bits = roundup_pow_of_two(round_up(gc->ngpio, 8));
 
 	ret = bgpio_setup_io(gc, dat, set, clr, flags);
 	if (ret)

drivers/gpio/gpiolib-of.c

@@ -202,6 +202,24 @@ static void of_gpio_try_fixup_polarity(const struct device_node *np,
 		 * helper, and be consistent with what other drivers do.
 		 */
 		{ "qi,lb60",		"rb-gpios",	true },
+#endif
+#if IS_ENABLED(CONFIG_PCI_LANTIQ)
+		/*
+		 * According to the PCI specification, the RST# pin is an
+		 * active-low signal. However, most of the device trees that
+		 * have been widely used for a long time incorrectly describe
+		 * reset GPIO as active-high, and were also using wrong name
+		 * for the property.
+		 */
+		{ "lantiq,pci-xway",	"gpio-reset",	false },
+#endif
+#if IS_ENABLED(CONFIG_TOUCHSCREEN_TSC2005)
+		/*
+		 * DTS for Nokia N900 incorrectly specified "active high"
+		 * polarity for the reset line, while the chip actually
+		 * treats it as "active low".
+		 */
+		{ "ti,tsc2005",		"reset-gpios",	false },
 #endif
 	};
 	unsigned int i;
@@ -504,9 +522,9 @@ static struct gpio_desc *of_find_gpio_rename(struct device_node *np,
 		{ "reset",	"reset-n-io",	"marvell,nfc-uart" },
 		{ "reset",	"reset-n-io",	"mrvl,nfc-uart" },
 #endif
-#if !IS_ENABLED(CONFIG_PCI_LANTIQ)
+#if IS_ENABLED(CONFIG_PCI_LANTIQ)
 		/* MIPS Lantiq PCI */
-		{ "reset",	"gpios-reset",	"lantiq,pci-xway" },
+		{ "reset",	"gpio-reset",	"lantiq,pci-xway" },
 #endif
 
 		/*