Merge tag 'pinctrl-v3.18-2' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl

Pull pin-control fixes from Linus Walleij:
 "This kernel cycle has been calm for both pin control and GPIO so far
  but here are three pin control patches for you anyway, only really
  dealing with Baytrail:

   - Two fixes for the Baytrail driver affecting IRQs and output state
     in sysfs
   - Use the linux-gpio mailing list also for pinctrl patches"

* tag 'pinctrl-v3.18-2' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl:
  pinctrl: baytrail: show output gpio state correctly on Intel Baytrail
  pinctrl: use linux-gpio mailing list
  pinctrl: baytrail: Clear DIRECT_IRQ bit

MAINTAINERS

@@ -7180,6 +7180,7 @@ F:	drivers/crypto/picoxcell*
 
 PIN CONTROL SUBSYSTEM
 M:	Linus Walleij <linus.walleij@linaro.org>
+L:	linux-gpio@vger.kernel.org
 S:	Maintained
 F:	drivers/pinctrl/
 F:	include/linux/pinctrl/

drivers/pinctrl/pinctrl-baytrail.c

@@ -227,10 +227,14 @@ static int byt_irq_type(struct irq_data *d, unsigned type)
 	spin_lock_irqsave(&vg->lock, flags);
 	value = readl(reg);
 
+	WARN(value & BYT_DIRECT_IRQ_EN,
+		"Bad pad config for io mode, force direct_irq_en bit clearing");
+
 	/* For level trigges the BYT_TRIG_POS and BYT_TRIG_NEG bits
 	 * are used to indicate high and low level triggering
 	 */
-	value &= ~(BYT_TRIG_POS | BYT_TRIG_NEG | BYT_TRIG_LVL);
+	value &= ~(BYT_DIRECT_IRQ_EN | BYT_TRIG_POS | BYT_TRIG_NEG |
+		   BYT_TRIG_LVL);
 
 	switch (type) {
 	case IRQ_TYPE_LEVEL_HIGH:
@@ -318,7 +322,7 @@ static int byt_gpio_direction_output(struct gpio_chip *chip,
 		"Potential Error: Setting GPIO with direct_irq_en to output");
 
 	reg_val = readl(reg) | BYT_DIR_MASK;
-	reg_val &= ~BYT_OUTPUT_EN;
+	reg_val &= ~(BYT_OUTPUT_EN | BYT_INPUT_EN);
 
 	if (value)
 		writel(reg_val | BYT_LEVEL, reg);