net: freescale: select CONFIG_FIXED_PHY where needed

I ran into a randconfig build failure with CONFIG_FIXED_PHY=m
and CONFIG_GIANFAR=y:

x86_64-linux-ld: drivers/net/ethernet/freescale/gianfar.o:(.rodata+0x418): undefined reference to `fixed_phy_change_carrier'

It seems the same thing can happen with dpaa and ucc_geth, so change
all three to do an explicit 'select FIXED_PHY'.

The fixed-phy driver actually has an alternative stub function that
theoretically allows building network drivers when fixed-phy is
disabled, but I don't see how that would help here, as the drivers
presumably would not work then.
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

drivers/net/ethernet/freescale/Kconfig

@@ -77,6 +77,7 @@ config UCC_GETH
 	depends on QUICC_ENGINE && PPC32
 	select FSL_PQ_MDIO
 	select PHYLIB
+	select FIXED_PHY
 	---help---
 	  This driver supports the Gigabit Ethernet mode of the QUICC Engine,
 	  which is available on some Freescale SOCs.
@@ -90,6 +91,7 @@ config GIANFAR
 	depends on HAS_DMA
 	select FSL_PQ_MDIO
 	select PHYLIB
+	select FIXED_PHY
 	select CRC32
 	---help---
 	  This driver supports the Gigabit TSEC on the MPC83xx, MPC85xx,

drivers/net/ethernet/freescale/dpaa/Kconfig

@@ -3,6 +3,7 @@ menuconfig FSL_DPAA_ETH
 	tristate "DPAA Ethernet"
 	depends on FSL_DPAA && FSL_FMAN
 	select PHYLIB
+	select FIXED_PHY
 	select FSL_FMAN_MAC
 	---help---
 	  Data Path Acceleration Architecture Ethernet driver,