ath10k: Fix the tx stats bytes & packets parsing

In tx_stats debugfs, txrate->flags may contain multiple bits. For
example, RATE_INFO_FLAGS_SHORT_GI could be set, and tx stats bytes
and packets will be not updated correctly.

Fix this issue by using bit operation to check txrate->flags.

Tested HW: QCA9984
Tested Firmware: 10.4-3.9.0.1-00007
Signed-off-by: Brandon Huang <yanghuan@codeaurora.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/ath/ath10k/htt_rx.c

@@ -3256,14 +3256,14 @@ ath10k_accumulate_per_peer_tx_stats(struct ath10k *ar,
 
 #define STATS_OP_FMT(name) tx_stats->stats[ATH10K_STATS_TYPE_##name]
 
-	if (txrate->flags == RATE_INFO_FLAGS_VHT_MCS) {
+	if (txrate->flags & RATE_INFO_FLAGS_VHT_MCS) {
 		STATS_OP_FMT(SUCC).vht[0][mcs] += pstats->succ_bytes;
 		STATS_OP_FMT(SUCC).vht[1][mcs] += pstats->succ_pkts;
 		STATS_OP_FMT(FAIL).vht[0][mcs] += pstats->failed_bytes;
 		STATS_OP_FMT(FAIL).vht[1][mcs] += pstats->failed_pkts;
 		STATS_OP_FMT(RETRY).vht[0][mcs] += pstats->retry_bytes;
 		STATS_OP_FMT(RETRY).vht[1][mcs] += pstats->retry_pkts;
-	} else if (txrate->flags == RATE_INFO_FLAGS_MCS) {
+	} else if (txrate->flags & RATE_INFO_FLAGS_MCS) {
 		STATS_OP_FMT(SUCC).ht[0][ht_idx] += pstats->succ_bytes;
 		STATS_OP_FMT(SUCC).ht[1][ht_idx] += pstats->succ_pkts;
 		STATS_OP_FMT(FAIL).ht[0][ht_idx] += pstats->failed_bytes;
@@ -3284,7 +3284,7 @@ ath10k_accumulate_per_peer_tx_stats(struct ath10k *ar,
 	if (ATH10K_HW_AMPDU(pstats->flags)) {
 		tx_stats->ba_fails += ATH10K_HW_BA_FAIL(pstats->flags);
 
-		if (txrate->flags == RATE_INFO_FLAGS_MCS) {
+		if (txrate->flags & RATE_INFO_FLAGS_MCS) {
 			STATS_OP_FMT(AMPDU).ht[0][ht_idx] +=
 				pstats->succ_bytes + pstats->retry_bytes;
 			STATS_OP_FMT(AMPDU).ht[1][ht_idx] +=