Commit 9e56ff53 authored by Christian Marangi's avatar Christian Marangi Committed by Jakub Kicinski

net: phy: move at803x PHY driver to dedicated directory

In preparation for addition of other Qcom PHY and to tidy things up,
move the at803x PHY driver to dedicated directory.

The same order in the Kconfig selection is saved.
Signed-off-by: default avatarChristian Marangi <ansuelsmth@gmail.com>
Reviewed-by: default avatarAndrew Lunn <andrew@lunn.ch>
Link: https://lore.kernel.org/r/20240129141600.2592-2-ansuelsmth@gmail.comSigned-off-by: default avatarJakub Kicinski <kuba@kernel.org>
parent 3a78983d
......@@ -335,12 +335,7 @@ config NCN26000_PHY
Currently supports the NCN26000 10BASE-T1S Industrial PHY
with MII interface.
config AT803X_PHY
tristate "Qualcomm Atheros AR803X PHYs and QCA833x PHYs"
depends on REGULATOR
help
Currently supports the AR8030, AR8031, AR8033, AR8035 and internal
QCA8337(Internal qca8k PHY) model
source "drivers/net/phy/qcom/Kconfig"
config QSEMI_PHY
tristate "Quality Semiconductor PHYs"
......
......@@ -36,7 +36,6 @@ obj-$(CONFIG_ADIN_PHY) += adin.o
obj-$(CONFIG_ADIN1100_PHY) += adin1100.o
obj-$(CONFIG_AMD_PHY) += amd.o
obj-$(CONFIG_AQUANTIA_PHY) += aquantia/
obj-$(CONFIG_AT803X_PHY) += at803x.o
ifdef CONFIG_AX88796B_RUST_PHY
obj-$(CONFIG_AX88796B_PHY) += ax88796b_rust.o
else
......@@ -91,6 +90,7 @@ endif
obj-$(CONFIG_NXP_C45_TJA11XX_PHY) += nxp-c45-tja.o
obj-$(CONFIG_NXP_CBTX_PHY) += nxp-cbtx.o
obj-$(CONFIG_NXP_TJA11XX_PHY) += nxp-tja11xx.o
obj-y += qcom/
obj-$(CONFIG_QSEMI_PHY) += qsemi.o
obj-$(CONFIG_REALTEK_PHY) += realtek.o
obj-$(CONFIG_RENESAS_PHY) += uPD60620.o
......
# SPDX-License-Identifier: GPL-2.0-only
config AT803X_PHY
tristate "Qualcomm Atheros AR803X PHYs and QCA833x PHYs"
depends on REGULATOR
help
Currently supports the AR8030, AR8031, AR8033, AR8035 and internal
QCA8337(Internal qca8k PHY) model
# SPDX-License-Identifier: GPL-2.0
obj-$(CONFIG_AT803X_PHY) += at803x.o
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment