Commit 9edd4f5a authored by Aidan MacDonald's avatar Aidan MacDonald Committed by Mark Brown

regmap-irq: Deprecate type registers and virtual registers

Config registers can be used to replace both type and virtual
registers, so mark both features are deprecated and issue a
warning if they're used.
Signed-off-by: default avatarAidan MacDonald <aidanmacdonald.0x0@gmail.com>
Link: https://lore.kernel.org/r/20220623211420.918875-10-aidanmacdonald.0x0@gmail.comSigned-off-by: default avatarMark Brown <broonie@kernel.org>
parent faa87ce9
......@@ -726,6 +726,12 @@ int regmap_add_irq_chip_fwnode(struct fwnode_handle *fwnode,
return -EINVAL;
}
if (chip->num_type_reg)
dev_warn(map->dev, "type registers are deprecated; use config registers instead");
if (chip->num_virt_regs || chip->virt_reg_base || chip->set_type_virt)
dev_warn(map->dev, "virtual registers are deprecated; use config registers instead");
if (irq_base) {
irq_base = irq_alloc_descs(irq_base, 0, chip->num_irqs, 0);
if (irq_base < 0) {
......
......@@ -1473,8 +1473,10 @@ struct regmap_irq_sub_irq_map {
* @ack_base: Base ack address. If zero then the chip is clear on read.
* Using zero value is possible with @use_ack bit.
* @wake_base: Base address for wake enables. If zero unsupported.
* @type_base: Base address for irq type. If zero unsupported.
* @virt_reg_base: Base addresses for extra config regs.
* @type_base: Base address for irq type. If zero unsupported. Deprecated,
* use @config_base instead.
* @virt_reg_base: Base addresses for extra config regs. Deprecated, use
* @config_base instead.
* @config_base: Base address for IRQ type config regs. If null unsupported.
* @irq_reg_stride: Stride to use for chips where registers are not contiguous.
* @init_ack_masked: Ack all masked interrupts once during initalization.
......@@ -1483,7 +1485,8 @@ struct regmap_irq_sub_irq_map {
* @ack_invert: Inverted ack register: cleared bits for ack.
* @clear_ack: Use this to set 1 and 0 or vice-versa to clear interrupts.
* @wake_invert: Inverted wake register: cleared bits are wake enabled.
* @type_invert: Invert the type flags.
* @type_invert: Invert the type flags. Deprecated, use config registers
* instead.
* @type_in_mask: Use the mask registers for controlling irq type. Use this if
* the hardware provides separate bits for rising/falling edge
* or low/high level interrupts and they should be combined into
......@@ -1502,9 +1505,11 @@ struct regmap_irq_sub_irq_map {
* @irqs: Descriptors for individual IRQs. Interrupt numbers are
* assigned based on the index in the array of the interrupt.
* @num_irqs: Number of descriptors.
* @num_type_reg: Number of type registers.
* @num_type_reg: Number of type registers. Deprecated, use config registers
* instead.
* @num_virt_regs: Number of non-standard irq configuration registers.
* If zero unsupported.
* If zero unsupported. Deprecated, use config registers
* instead.
* @num_config_bases: Number of config base registers.
* @num_config_regs: Number of config registers for each config base register.
* @handle_pre_irq: Driver specific callback to handle interrupt from device
......@@ -1512,7 +1517,8 @@ struct regmap_irq_sub_irq_map {
* @handle_post_irq: Driver specific callback to handle interrupt from device
* after handling the interrupts in regmap_irq_handler().
* @set_type_virt: Driver specific callback to extend regmap_irq_set_type()
* and configure virt regs.
* and configure virt regs. Deprecated, use @set_type_config
* callback and config registers instead.
* @set_type_config: Callback used for configuring irq types.
* @irq_drv_data: Driver specific IRQ data which is passed as parameter when
* driver specific pre/post interrupt handler is called.
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment