arm64: dts: qcom: sdm630-pm660: Move RESIN to pm660 dtsi

It's not worth duplicating the same node over and over again,
so let's keep the common bits in the pm660 DTSI, making only
changing the status and keycode necessary.

Also, disable RESIN/PWR by default just in case if there are
devices that doesn't use them.
Reviewed-by: Konrad Dybcio <konrad.dybcio@somainline.org>
Signed-off-by: Dang Huynh <danct12@riseup.net>
Reviewed-by: Caleb Connolly <caleb@connolly.tech>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20211120214227.779742-3-danct12@riseup.net

arch/arm64/boot/dts/qcom/pm660.dtsi

@@ -54,14 +54,24 @@ pon: pon@800 {
 			mode-bootloader = <0x2>;
 			mode-recovery = <0x1>;
 
-			pwrkey {
+			pon_pwrkey: pwrkey {
 				compatible = "qcom,pm8941-pwrkey";
 				interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
 				debounce = <15625>;
 				bias-pull-up;
 				linux,code = <KEY_POWER>;
+
+				status = "disabled";
 			};
 
+			pon_resin: resin {
+				compatible = "qcom,pm8941-resin";
+				interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
+				debounce = <15625>;
+				bias-pull-up;
+
+				status = "disabled";
+			};
 		};
 
 		pm660_temp: temp-alarm@2400 {

arch/arm64/boot/dts/qcom/sdm630-sony-xperia-nile.dtsi

@@ -215,14 +215,14 @@ &blsp2_uart1 {
 	/* HCI Bluetooth */
 };
 
-&pon {
-	volup {
-		compatible = "qcom,pm8941-resin";
-		interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
-		debounce = <15625>;
-		bias-pull-up;
-		linux,code = <KEY_VOLUMEUP>;
-	};
+&pon_pwrkey {
+	status = "okay";
+};
+
+&pon_resin {
+	status = "okay";
+
+	linux,code = <KEY_VOLUMEUP>;
 };
 
 &qusb2phy {