Commit 9f70e48e authored by Mauro Carvalho Chehab's avatar Mauro Carvalho Chehab Committed by Jonathan Corbet

docs: misc-devices/apds990x.txt: convert to ReST format

- Adjust title markup;
- Adjust identation.
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab+huawei@kernel.org>
Link: https://lore.kernel.org/r/444743782e5c8b8085d8016c8be3baabe4d23b53.1592203650.git.mchehab+huawei@kernel.orgSigned-off-by: default avatarJonathan Corbet <corbet@lwn.net>
parent 0e7ade47
.. SPDX-License-Identifier: GPL-2.0
======================
Kernel driver apds990x
======================
......@@ -50,14 +53,18 @@ chip_id
power_state
RW - enable / disable chip. Uses counting logic
1 enables the chip
0 disables the chip
lux0_input
RO - measured lux value
sysfs_notify called when threshold interrupt occurs
lux0_sensor_range
RO - lux0_input max value. Actually never reaches since sensor tends
RO - lux0_input max value.
Actually never reaches since sensor tends
to saturate much before that. Real max value varies depending
on the light spectrum etc.
......@@ -68,7 +75,9 @@ lux0_rate_avail
RO - supported measurement rates
lux0_calibscale
RW - calibration value. Set to neutral value by default.
RW - calibration value.
Set to neutral value by default.
Output results are multiplied with calibscale / calibscale_default
value.
......@@ -76,16 +85,21 @@ lux0_calibscale_default
RO - neutral calibration value
lux0_thresh_above_value
RW - HI level threshold value. All results above the value
RW - HI level threshold value.
All results above the value
trigs an interrupt. 65535 (i.e. sensor_range) disables the above
interrupt.
lux0_thresh_below_value
RW - LO level threshold value. All results below the value
RW - LO level threshold value.
All results below the value
trigs an interrupt. 0 disables the below interrupt.
prox0_raw
RO - measured proximity value
sysfs_notify called when threshold interrupt occurs
prox0_sensor_range
......@@ -93,11 +107,14 @@ prox0_sensor_range
prox0_raw_en
RW - enable / disable proximity - uses counting logic
1 enables the proximity
0 disables the proximity
- 1 enables the proximity
- 0 disables the proximity
prox0_reporting_mode
RW - trigger / periodic. In "trigger" mode the driver tells two possible
RW - trigger / periodic.
In "trigger" mode the driver tells two possible
values: 0 or prox0_sensor_range value. 0 means no proximity,
1023 means proximity. This causes minimal number of interrupts.
In "periodic" mode the driver reports all values above
......
......@@ -15,6 +15,7 @@ fit into other categories.
:maxdepth: 2
ad525x_dpot
apds990x
bh1770glc
eeprom
c2port
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment