Commit a0b835e4 authored by Andrew Lunn's avatar Andrew Lunn Committed by Shawn Guo

ARM: dts: imx6: RDU2: Add Micrel PHY interrupt

The Micrel PHY has its interrupt pin connected to a GPIO line. Wire
this up in the device tree.
Signed-off-by: default avatarAndrew Lunn <andrew@lunn.ch>
Tested-by: default avatarChris Healy <cphealy@gmail.com>
Reviewed-by: default avatarFabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: default avatarShawn Guo <shawnguo@kernel.org>
parent f64992d1
...@@ -61,7 +61,11 @@ mdio1: mdio { ...@@ -61,7 +61,11 @@ mdio1: mdio {
&gpio6 4 GPIO_ACTIVE_HIGH>; &gpio6 4 GPIO_ACTIVE_HIGH>;
phy: ethernet-phy@0 { phy: ethernet-phy@0 {
pinctrl-0 = <&pinctrl_rmii_phy_irq>;
pinctrl-names = "default";
reg = <0>; reg = <0>;
interrupt-parent = <&gpio3>;
interrupts = <30 IRQ_TYPE_LEVEL_LOW>;
}; };
}; };
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment