ata: Convert dev_printk(KERN_<LEVEL> to dev_<level>(

dev_<level> calls take less code than dev_printk(KERN_<LEVEL>
and reducing object size is good.
Coalesce formats for easier grep.
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

drivers/ata/pata_cmd64x.c

@@ -474,14 +474,14 @@ static int cmd64x_init_one(struct pci_dev *pdev, const struct pci_device_id *id)
 	/* check for enabled ports */
 	pci_read_config_byte(pdev, CNTRL, &reg);
 	if (!port_ok)
-		dev_printk(KERN_NOTICE, &pdev->dev, "Mobility Bridge detected, ignoring CNTRL port enable/disable\n");
+		dev_notice(&pdev->dev, "Mobility Bridge detected, ignoring CNTRL port enable/disable\n");
 	if (port_ok && cntrl_ch0_ok && !(reg & CNTRL_CH0)) {
-		dev_printk(KERN_NOTICE, &pdev->dev, "Primary port is disabled\n");
+		dev_notice(&pdev->dev, "Primary port is disabled\n");
 		ppi[0] = &ata_dummy_port_info;
 
 	}
 	if (port_ok && !(reg & CNTRL_CH1)) {
-		dev_printk(KERN_NOTICE, &pdev->dev, "Secondary port is disabled\n");
+		dev_notice(&pdev->dev, "Secondary port is disabled\n");
 		ppi[1] = &ata_dummy_port_info;
 	}