drm: Add driver for Solomon SSD130x OLED displays

This adds a DRM driver for SSD1305, SSD1306, SSD1307 and SSD1309 Solomon
OLED display controllers.

It's only the core part of the driver and a bus specific driver is needed
for each transport interface supported by the display controllers.
Signed-off-by: Javier Martinez Canillas <javierm@redhat.com>
Reviewed-by: Maxime Ripard <maxime@cerno.tech>
Link: https://patchwork.freedesktop.org/patch/msgid/20220214133710.3278506-4-javierm@redhat.com

drivers/gpu/drm/Kconfig

@@ -403,6 +403,8 @@ source "drivers/gpu/drm/xlnx/Kconfig"
 
 source "drivers/gpu/drm/gud/Kconfig"
 
+source "drivers/gpu/drm/solomon/Kconfig"
+
 source "drivers/gpu/drm/sprd/Kconfig"
 
 config DRM_HYPERV

drivers/gpu/drm/Makefile

@@ -132,4 +132,5 @@ obj-$(CONFIG_DRM_TIDSS) += tidss/
 obj-y			+= xlnx/
 obj-y			+= gud/
 obj-$(CONFIG_DRM_HYPERV) += hyperv/
+obj-y			+= solomon/
 obj-$(CONFIG_DRM_SPRD) += sprd/

drivers/gpu/drm/solomon/Kconfig

+config DRM_SSD130X
+	tristate "DRM support for Solomon SSD130x OLED displays"
+	depends on DRM
+	select BACKLIGHT_CLASS_DEVICE
+	select DRM_GEM_SHMEM_HELPER
+	select DRM_KMS_HELPER
+	help
+	  DRM driver for the SSD1305, SSD1306, SSD1307 and SSD1309 Solomon
+	  OLED controllers. This is only for the core driver, a driver for
+	  the appropriate bus transport in your chip also must be selected.
+
+	  If M is selected the module will be called ssd130x.

drivers/gpu/drm/solomon/Makefile

+obj-$(CONFIG_DRM_SSD130X)	+= ssd130x.o

drivers/gpu/drm/solomon/ssd130x.h

+/* SPDX-License-Identifier: GPL-2.0-only */
+/*
+ * Header file for:
+ * DRM driver for Solomon SSD130x OLED displays
+ *
+ * Copyright 2022 Red Hat Inc.
+ * Author: Javier Martinez Canillas <javierm@redhat.com>
+ *
+ * Based on drivers/video/fbdev/ssd1307fb.c
+ * Copyright 2012 Free Electrons
+ */
+
+#ifndef __SSD1307X_H__
+#define __SSD1307X_H__
+
+#include <drm/drm_drv.h>
+#include <drm/drm_simple_kms_helper.h>
+
+#include <linux/regmap.h>
+
+struct ssd130x_deviceinfo {
+	u32 default_vcomh;
+	u32 default_dclk_div;
+	u32 default_dclk_frq;
+	int need_pwm;
+	int need_chargepump;
+};
+
+struct ssd130x_device {
+	struct drm_device drm;
+	struct device *dev;
+	struct drm_simple_display_pipe pipe;
+	struct drm_display_mode mode;
+	struct drm_connector connector;
+	struct i2c_client *client;
+
+	struct regmap *regmap;
+
+	const struct ssd130x_deviceinfo *device_info;
+
+	unsigned area_color_enable : 1;
+	unsigned com_invdir : 1;
+	unsigned com_lrremap : 1;
+	unsigned com_seq : 1;
+	unsigned lookup_table_set : 1;
+	unsigned low_power : 1;
+	unsigned seg_remap : 1;
+	u32 com_offset;
+	u32 contrast;
+	u32 dclk_div;
+	u32 dclk_frq;
+	u32 height;
+	u8 lookup_table[4];
+	u32 page_offset;
+	u32 col_offset;
+	u32 prechargep1;
+	u32 prechargep2;
+
+	struct backlight_device *bl_dev;
+	struct pwm_device *pwm;
+	struct gpio_desc *reset;
+	struct regulator *vcc_reg;
+	u32 vcomh;
+	u32 width;
+	/* Cached address ranges */
+	u8 col_start;
+	u8 col_end;
+	u8 page_start;
+	u8 page_end;
+};
+
+struct ssd130x_device *ssd130x_probe(struct device *dev, struct regmap *regmap);
+int ssd130x_remove(struct ssd130x_device *ssd130x);
+void ssd130x_shutdown(struct ssd130x_device *ssd130x);
+
+#endif /* __SSD1307X_H__ */