pinctrl: mediatek: Add Pinctrl/GPIO driver for mt8135.

The mediatek SoCs have GPIO controller that handle both the muxing and GPIOs.

The GPIO controller have pinmux, pull enable, pull select, direction and output high/low control.

This driver include common driver and mt8135 part.
The common driver include the pinctrl driver and GPIO driver.
The mt8135 part contain its special device data.
Signed-off-by: Hongzhou Yang <hongzhou.yang@mediatek.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

drivers/pinctrl/Kconfig

@@ -205,6 +205,7 @@ source "drivers/pinctrl/sh-pfc/Kconfig"
 source "drivers/pinctrl/spear/Kconfig"
 source "drivers/pinctrl/sunxi/Kconfig"
 source "drivers/pinctrl/vt8500/Kconfig"
+source "drivers/pinctrl/mediatek/Kconfig"
 
 config PINCTRL_XWAY
 	bool

drivers/pinctrl/Makefile

@@ -49,3 +49,4 @@ obj-$(CONFIG_PINCTRL_SH_PFC)	+= sh-pfc/
 obj-$(CONFIG_PLAT_SPEAR)	+= spear/
 obj-$(CONFIG_ARCH_SUNXI)	+= sunxi/
 obj-$(CONFIG_ARCH_VT8500)	+= vt8500/
+obj-$(CONFIG_ARCH_MEDIATEK)	+= mediatek/

drivers/pinctrl/mediatek/Kconfig

+if ARCH_MEDIATEK
+
+config PINCTRL_MTK_COMMON
+	bool
+	select PINMUX
+	select GENERIC_PINCONF
+	select GPIOLIB
+	select OF_GPIO
+
+config PINCTRL_MT8135
+	def_bool MACH_MT8135
+	select PINCTRL_MTK_COMMON
+
+endif

drivers/pinctrl/mediatek/Makefile

+# Core
+obj-$(CONFIG_PINCTRL_MTK_COMMON)	+= pinctrl-mtk-common.o
+
+# SoC Drivers
+obj-$(CONFIG_PINCTRL_MT8135)		+= pinctrl-mt8135.o

drivers/pinctrl/mediatek/pinctrl-mtk-common.h

+/*
+ * Copyright (c) 2014 MediaTek Inc.
+ * Author: Hongzhou.Yang <hongzhou.yang@mediatek.com>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+ * GNU General Public License for more details.
+ */
+
+#ifndef __PINCTRL_MTK_COMMON_H
+#define __PINCTRL_MTK_COMMON_H
+
+#include <linux/pinctrl/pinctrl.h>
+#include <linux/spinlock.h>
+#include <linux/regmap.h>
+
+#define NO_EINT_SUPPORT    255
+
+struct mtk_desc_function {
+	const char *name;
+	unsigned char muxval;
+};
+
+struct mtk_desc_eint {
+	unsigned char eintmux;
+	unsigned char eintnum;
+};
+
+struct mtk_desc_pin {
+	struct pinctrl_pin_desc	pin;
+	const char *chip;
+	const struct mtk_desc_eint eint;
+	const struct mtk_desc_function	*functions;
+};
+
+#define MTK_PIN(_pin, _pad, _chip, _eint, ...)		\
+	{							\
+		.pin = _pin,					\
+		.chip = _chip,					\
+		.eint = _eint,					\
+		.functions = (struct mtk_desc_function[]){	\
+			__VA_ARGS__, { } },			\
+	}
+
+#define MTK_EINT_FUNCTION(_eintmux, _eintnum)				\
+	{							\
+		.eintmux = _eintmux,					\
+		.eintnum = _eintnum,					\
+	}
+
+#define MTK_FUNCTION(_val, _name)				\
+	{							\
+		.muxval = _val,					\
+		.name = _name,					\
+	}
+
+#define SET_ADDR(x, y)  (x + (y->devdata->port_align))
+#define CLR_ADDR(x, y)  (x + (y->devdata->port_align << 1))
+
+struct mtk_pinctrl_group {
+	const char	*name;
+	unsigned long	config;
+	unsigned	pin;
+};
+
+/**
+ * struct mtk_drv_group_desc - Provide driving group data.
+ * @max_drv: The maximum current of this group.
+ * @min_drv: The minimum current of this group.
+ * @low_bit: The lowest bit of this group.
+ * @high_bit: The highest bit of this group.
+ * @step: The step current of this group.
+ */
+struct mtk_drv_group_desc {
+	unsigned char min_drv;
+	unsigned char max_drv;
+	unsigned char low_bit;
+	unsigned char high_bit;
+	unsigned char step;
+};
+
+#define MTK_DRV_GRP(_min, _max, _low, _high, _step)	\
+	{	\
+		.min_drv = _min,	\
+		.max_drv = _max,	\
+		.low_bit = _low,	\
+		.high_bit = _high,	\
+		.step = _step,		\
+	}
+
+/**
+ * struct mtk_pin_drv_grp - Provide each pin driving info.
+ * @pin: The pin number.
+ * @offset: The offset of driving register for this pin.
+ * @bit: The bit of driving register for this pin.
+ * @grp: The group for this pin belongs to.
+ */
+struct mtk_pin_drv_grp {
+	unsigned int pin;
+	unsigned int offset;
+	unsigned char bit;
+	unsigned char grp;
+};
+
+#define MTK_PIN_DRV_GRP(_pin, _offset, _bit, _grp)	\
+	{	\
+		.pin = _pin,	\
+		.offset = _offset,	\
+		.bit = _bit,	\
+		.grp = _grp,	\
+	}
+
+/**
+ * struct mtk_pinctrl_devdata - Provide HW GPIO related data.
+ * @pins: An array describing all pins the pin controller affects.
+ * @npins: The number of entries in @pins.
+ *
+ * @grp_desc: The driving group info.
+ * @pin_drv_grp: The driving group for all pins.
+ * @spec_pull_set: Each SoC may have special pins for pull up/down setting,
+ *  these pins' pull setting are very different, they have separate pull
+ *  up/down bit, R0 and R1 resistor bit, so they need special pull setting.
+ *  If special setting is success, this should return 0, otherwise it should
+ *  return non-zero value.
+ *
+ * @dir_offset: The direction register offset.
+ * @pullen_offset: The pull-up/pull-down enable register offset.
+ * @pinmux_offset: The pinmux register offset.
+ *
+ * @type1_start: Some chips have two base addresses for pull select register,
+ *  that means some pins use the first address and others use the second. This
+ *  member record the start of pin number to use the second address.
+ * @type1_end: The end of pin number to use the second address.
+ *
+ * @port_shf: The shift between two registers.
+ * @port_mask: The mask of register.
+ * @port_align: Provide clear register and set register step.
+ */
+struct mtk_pinctrl_devdata {
+	const struct mtk_desc_pin	*pins;
+	unsigned int				npins;
+	const struct mtk_drv_group_desc	*grp_desc;
+	unsigned int	n_grp_cls;
+	const struct mtk_pin_drv_grp	*pin_drv_grp;
+	unsigned int	n_pin_drv_grps;
+	int (*spec_pull_set)(struct regmap *reg, unsigned int pin,
+			unsigned char align, bool isup, unsigned int arg);
+	unsigned int dir_offset;
+	unsigned int ies_offset;
+	unsigned int smt_offset;
+	unsigned int pullen_offset;
+	unsigned int pullsel_offset;
+	unsigned int drv_offset;
+	unsigned int invser_offset;
+	unsigned int dout_offset;
+	unsigned int din_offset;
+	unsigned int pinmux_offset;
+	unsigned short type1_start;
+	unsigned short type1_end;
+	unsigned char  port_shf;
+	unsigned char  port_mask;
+	unsigned char  port_align;
+};
+
+struct mtk_pinctrl {
+	struct regmap	*regmap1;
+	struct regmap	*regmap2;
+	struct device           *dev;
+	struct gpio_chip	*chip;
+	struct mtk_pinctrl_group	*groups;
+	unsigned			ngroups;
+	const char          **grp_names;
+	struct pinctrl_dev      *pctl_dev;
+	const struct mtk_pinctrl_devdata  *devdata;
+};
+
+int mtk_pctrl_init(struct platform_device *pdev,
+		const struct mtk_pinctrl_devdata *data);
+
+#endif /* __PINCTRL_MTK_COMMON_H */

include/dt-bindings/pinctrl/mt65xx.h

+/*
+ * Copyright (c) 2014 MediaTek Inc.
+ * Author: Hongzhou.Yang <hongzhou.yang@mediatek.com>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+ * GNU General Public License for more details.
+ */
+
+#ifndef _DT_BINDINGS_PINCTRL_MT65XX_H
+#define _DT_BINDINGS_PINCTRL_MT65XX_H
+
+#define MTK_PIN_NO(x) ((x) << 8)
+#define MTK_GET_PIN_NO(x) ((x) >> 8)
+#define MTK_GET_PIN_FUNC(x) ((x) & 0xf)
+
+#define MTK_PUPD_SET_R1R0_00 100
+#define MTK_PUPD_SET_R1R0_01 101
+#define MTK_PUPD_SET_R1R0_10 102
+#define MTK_PUPD_SET_R1R0_11 103
+
+#define MTK_DRIVE_2mA  2
+#define MTK_DRIVE_4mA  4
+#define MTK_DRIVE_6mA  6
+#define MTK_DRIVE_8mA  8
+#define MTK_DRIVE_10mA 10
+#define MTK_DRIVE_12mA 12
+#define MTK_DRIVE_14mA 14
+#define MTK_DRIVE_16mA 16
+#define MTK_DRIVE_20mA 20
+#define MTK_DRIVE_24mA 24
+#define MTK_DRIVE_28mA 28
+#define MTK_DRIVE_32mA 32
+
+#endif /* _DT_BINDINGS_PINCTRL_MT65XX_H */