Commit a89ab114 authored by Peter Ma's avatar Peter Ma Committed by Haavard Skinnemoen

avr32: Change Atmel ATNGW100 config to add choice of add-on board

Signed-off-by: default avatarPeter Ma <pma@mediamatech.com>
Signed-off-by: default avatarHaavard Skinnemoen <haavard.skinnemoen@atmel.com>
parent 334034c1
...@@ -2,8 +2,15 @@ ...@@ -2,8 +2,15 @@
if BOARD_ATNGW100 if BOARD_ATNGW100
choice
prompt "Select an NGW100 add-on board to support"
default BOARD_ATNGW100_ADDON_NONE
config BOARD_ATNGW100_ADDON_NONE
bool "None"
config BOARD_ATNGW100_EVKLCD10X config BOARD_ATNGW100_EVKLCD10X
bool "Add support for EVKLCD10X addon board" bool "EVKLCD10X addon board"
help help
This enables support for the EVKLCD100 (QVGA) or EVKLCD101 (VGA) This enables support for the EVKLCD100 (QVGA) or EVKLCD101 (VGA)
addon board for the NGW100. By enabling this the LCD controller and addon board for the NGW100. By enabling this the LCD controller and
...@@ -14,7 +21,7 @@ config BOARD_ATNGW100_EVKLCD10X ...@@ -14,7 +21,7 @@ config BOARD_ATNGW100_EVKLCD10X
The MCI pins can be reenabled by editing the "add device function" but The MCI pins can be reenabled by editing the "add device function" but
this may break the setup for other displays that use these pins. this may break the setup for other displays that use these pins.
Choose 'Y' here if you have a EVKLCD100/101 connected to the NGW100. endchoice
choice choice
prompt "LCD panel resolution on EVKLCD10X" prompt "LCD panel resolution on EVKLCD10X"
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment