Commit a8a16454 authored by Brian Norris's avatar Brian Norris

mtd: spi-nor: make bitfield constants more consistent

These status bits use different ways of representing similar integer
constants -- some are decimal, some are hex. Make them more consistent.

At the same time, impose my own preference, since IMO it's clearer what
these are when using the BIT() macro.
Signed-off-by: default avatarBrian Norris <computersforpeace@gmail.com>
parent 801cf21b
...@@ -63,24 +63,24 @@ ...@@ -63,24 +63,24 @@
#define SPINOR_OP_WD_EVCR 0x61 /* Write EVCR register */ #define SPINOR_OP_WD_EVCR 0x61 /* Write EVCR register */
/* Status Register bits. */ /* Status Register bits. */
#define SR_WIP 1 /* Write in progress */ #define SR_WIP BIT(0) /* Write in progress */
#define SR_WEL 2 /* Write enable latch */ #define SR_WEL BIT(1) /* Write enable latch */
/* meaning of other SR_* bits may differ between vendors */ /* meaning of other SR_* bits may differ between vendors */
#define SR_BP0 4 /* Block protect 0 */ #define SR_BP0 BIT(2) /* Block protect 0 */
#define SR_BP1 8 /* Block protect 1 */ #define SR_BP1 BIT(3) /* Block protect 1 */
#define SR_BP2 0x10 /* Block protect 2 */ #define SR_BP2 BIT(4) /* Block protect 2 */
#define SR_SRWD 0x80 /* SR write protect */ #define SR_SRWD BIT(7) /* SR write protect */
#define SR_QUAD_EN_MX 0x40 /* Macronix Quad I/O */ #define SR_QUAD_EN_MX BIT(6) /* Macronix Quad I/O */
/* Enhanced Volatile Configuration Register bits */ /* Enhanced Volatile Configuration Register bits */
#define EVCR_QUAD_EN_MICRON 0x80 /* Micron Quad I/O */ #define EVCR_QUAD_EN_MICRON BIT(7) /* Micron Quad I/O */
/* Flag Status Register bits */ /* Flag Status Register bits */
#define FSR_READY 0x80 #define FSR_READY BIT(7)
/* Configuration Register bits. */ /* Configuration Register bits. */
#define CR_QUAD_EN_SPAN 0x2 /* Spansion Quad I/O */ #define CR_QUAD_EN_SPAN BIT(1) /* Spansion Quad I/O */
enum read_mode { enum read_mode {
SPI_NOR_NORMAL = 0, SPI_NOR_NORMAL = 0,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment